Here I am

2nd Gen Non-Engine/Transmission Cab/ Body mounts

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff
Status
Not open for further replies.
Who has replaced their cab/ body mounts? I am doing a cab swap and the OEM mounts are intact and useable but have 220K on them. I'm looking at urethane mounts from various vendors. The truck is bone stock, no offroading and the like intended. Just figure that the originals are hardened and this would be the time to change them if it's worthwhile to do so.

Thanks in advance.
 
I have never replaced on that vehicle but have on others. In general (IMO) urethane mounts will be stiffer and will carry more vibration into the cab. The biggest plus for urethane is it is less costly than OEM but you get what you pay for. YMMV.



If it were mine, and mounts were in bad shape, I would replace with OEM.
 
I have never replaced on that vehicle but have on others. In general (IMO) urethane mounts will be stiffer and will carry more vibration into the cab. The biggest plus for urethane is it is less costly than OEM but you get what you pay for. YMMV.

If it were mine, and mounts were in bad shape, I would replace with OEM.

I agree, I don't recall any issues with 2nd Gen cab mounts being posted on here ever.

Go OEM for sure.

Mike.
 
Mine aren't damaged. I just figured that after 220k the rubber has hardened. Maybe I'll just put the old ones back on.
Thank you for the comments.
 
Status
Not open for further replies.
Back
Top