Recent Content by ahansen

I just purchased a set of 255/85's. I have the 5spd with the 4. 10. I like the 255's size better than the 235's I had before this. The 255's seem to ride better on the expressway. I was concerned with the extra height and towing ability with the 255's. But the bigger tire has not been a problem...

Bill, Last year I replaced the front rotors, after that the drivers side axle seal started to leak. I did a search on the TDR and found a lot of info & links that would help. Some of the guys said to give it time, that sometimes the seals will stop leaking. I know that my leak has stopped...

I tabbed the dowel pin this past weekend. I turned the engine a bit by using the bolts on the damper, it worked great. The pin was about 1/32 out and when I tapped it back in, it went in very easy. The job was not hard and if you take your time, it goes easy. I was concerned about putting the...

Thank you SEmerson, that should work. I am looking foreward to killing the KDP! TDR is a great resource.

I am planning to fix the KDP this week end. Reading the instruction on the TST kit, I see that I should check the 5 capscrews that hold the gear cover housing to the engine. But two of the capscrews are behind the cam gear and may require barring enjine to access them. I don't have a barring...

Using the Hayes repair book, I was able to test the relay and the heater. All looked ok expect that I could not get a connection though the heater temp sensor. Also, one of the connections from the relay to the heater was brittle and dark. I did clean the pre filter in the heater. I think I...

My '95 would not start, I will change the fuel filter but while working on it I found that the fuel heater is not working. I think the fuel temperture sensor is the problem. First, can I use the truck with out the fuel heater ( I live in Wisconsin)? Second, can I purchase just the sensor or...