Recent Content by atoalson

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff
  1. A

    What oil is in your Cummiins today ?

    Sounds like I'm the minority with Delvac 15w-40 in a Donaldson DBL7349. Ran same combo in my 2011.
  2. A

    G56 owners

    I've been using Amsoil MTF at the recommendation of Standard Transmission, for 4K miles. They feel the Amsoil MTG is a little on the thick side for the G56. Shifts are fine, I still find it difficult to be consistent with smooth shifts with the G56. I guess that what to expect from a medium duty...
  3. A

    Baldwin 7317 bypass filter

    I have had great results with Donaldson DBL7349. Used to be the ELF7349, very efficient and flows great GPM.
  4. A

    G56 small grind into 3rd gear

    I double clutched it several times this morning, went right into 3rd very easy. Wouldn't think you would have to do that, but it was smooth.
  5. A

    G56 small grind into 3rd gear

    That's good to know. Other than that, I love the trans. My wifes cousin has a '09 regular cab with a G56, he's very hard on things and it's lasted 186,000 miles with still the original ATF in it.
  6. A

    G56 small grind into 3rd gear

    Yes, if I shift a little higher in RPM range it seems to slide into 3rd easier. This may not make sense but, almost feels like the synchronizers aren't spinning fast enough(if that's how they work), when I'm below 2K RPM. If anything the AMSOIL has been an all around improvement. I knew I was...
  7. A

    G56 small grind into 3rd gear

    Hi all, My '16 RAM 3550 SRW seems to almost always have a small grind as I shift from 2nd to 3rd. All the other gear changes are smooth and you really cant feel much, but 2nd to 3rd, more time than not seems a little notchy. I typically shift just under 2K. Has anyone else with a G56...
See more
Back
Top