Recent Content by BDahm

I had the exact same issue about a year ago. I checked the crossover tubes and found a bad o ring. I know somebody said that doesn't seal the fuel but it was either a coincidence or the tube just needed to be reseated. But replacing the o rings defiantly fixed my identical issue.

Wow great info to know, im looking into it now and really appreciate your inputs. Its great to learn from others who have been there done that especially with a dreaded issue like finding an ECM and not getting robbed or screwed. Ill keep u guys posted thanks- Bryan

Thanks for the info guys, it is indeed the ECM. Swapped with my buddys 2000, ran fine but didn't seem like it had as much balls as before. And I'm going to take that sensor into consideration for future troubleshooting. On to finding a new ECM. Don't really wanna pay $450 on eBay. Any...

are 24 valve ecm's interchangeable? (98. 5-02) meaning i can swap mine with my buddys 99? or do they need to be set up for your vin and/or reflashed?

I have a similar problem right now, New apps didnt fix it either. I have a post i just put up too. Good luck and hopefully we can help eachother

Did the same thing not too long ago, like they said lower hose off and raise the back. Use an ELC like Fleetgaurd ES Complet and compensate for the water you used to flush in the block when mixing new coolant. Otherwise you guys pretty much said it all

OK guys I have an 02 auto. My problem is that I have a unresponsive pedal, cuts in and out. Heres my codes, p0122, p0236 and p1475. Have Edge Juice with attitude but removed it to troubleshoot. my scanner doesnt show the p1475, but the key trick does, weird. . So anyway i put a new vp44 on about...

on construction equipment with cummins its the same way, ecm gives the ground. Wow i learn something everytime i come on here! Nice work with the diagrams and explainations John, we appriciate it.

How do you check/reset the apps?? thanks

Yes the truck will either fire right away, rev up out of control then die or long crank them stumble and start normally. This problem started to happen after i installed the new vp and lp. I reomved the vp again sent it to industrial inj to have it checked, found no problems but was storing a...

Here is the problem im having. It either takes 5 sec of cranking to fire or starts right up and revs out completly the dies and no restart until i remove the engine fuse and put it back in. I replaced the vp, lp, crank sensor. Im thinking its an ecm issue. You guys heard of this???

12mm. i forget the pitch though! 1. 5 i think

i think it is a 12 or 13mm head on those bolts, just like everyone has already said, pb, 1/2 impact and extension, 6 pt socket, she'll be alright. Hammer down

haha yea true about it being a s. o. b to get to, luckely i have the pump off. Thanks guys

ok i know i have a cam sensor below the vp, but is there a crank sensor? Not one behind the starter, dont think there is one! Reason i ask is because appearently my Vp 44 module can store codes and i couldnt pull that code with the solus! I have a hard start problen and i ended up...