Recent Content by Budro

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff
  1. B

    Best Stupid Warning Labels Winner Gets CFM+ 5.9L Intake Manifold (Ends: May 25, 2012)

    From the 96 Dodge Ram tech manual: 5. 2L Engine pg 9-58, CAUTION: If oil pressure is zero (0) at curb idle, DO NOT run engine at 3000 RPM. 96 Extended cab, 4X2, 5spd, 3. 54, Fresh air intake, DDP stage 1 injectors, overhaul at 389K, Isspro boost and temp, otherwise stock. Jerry...
  2. B

    Engine/Transmission (1994 - 1998) No oil pressure

    I hooked up a 200lb gage to the 1/8 NPT port on top of the oil filter, ran it to the windshield wiper for a tempoary setup. Cold startup at idle, 40 on the dash, 105 on the filter! After reaching operating temp at idle, 35 on the dash, 55 on the filter. 5 minutes after startup, at 2K RPM the...
  3. B

    Engine/Transmission (1994 - 1998) No oil pressure

    I hooked up a 200lb gage to the 1/8 NPT port on top of the oil filter, ran it to the windshield wiper for a tempoary setup. Cold startup at idle, 40 on the dash, 105 on the filter! After reaching operating temp at idle, 35 on the dash, 55 on the filter. 5 minutes after startup, at 2K RPM the...
  4. B

    Engine/Transmission (1994 - 1998) No oil pressure

    Mr. Ames I too was hooked into the 1/8 NPT port on top of the oil filter for the mechanical guage. When it started the dash gage held at 40 and the mechanical when to 75 at idle! I was afraid to state this orgionally cause I thought the old gage I was using may have been off. I have not had...
  5. B

    Engine/Transmission (1994 - 1998) No oil pressure

    Thanks to everyone for their reply to my delima of no oil press during cranking. After talking to a former Dodge diesel mechanic, I am back in the land of diesel fumes again. He suggested to keep cranking for at least 1min or until it cranked - which ever comes first. I primed the injectors...
  6. B

    Engine/Transmission (1994 - 1998) No oil pressure

    Thanks to everyone for their reply to my delima of no oil press during cranking. After talking to a former Dodge diesel mechanic, I am back in the land of diesel fumes again. He suggested to keep cranking for at least 1min or until it cranked - which ever comes first. I primed the injectors...
  7. B

    Engine/Transmission (1994 - 1998) No oil pressure

    I have just completed overhauling my 96 12v at 389K. New brgs, rings, gaskets, seals, head worked, new valve springs, new HD clutch, DDP stage 1 injectors, etc..... At start up I was waiting on oil pressure to come up before I allowed fuel to the injectors. Allowing the starter only 15 sec...
  8. B

    Archived Rod and Main Bolts for 96- 12v

    96 12v rod and main bolts Thanks for the replys. I have found the bolts. I can get them only from Cummins. If the egale flies on time I should get them tomorrow. Thanks again for your help. Jerry Jones Graham, Texas 96 extened cab, 4X2, 5spd, 3. 54, boost and temp guages Stage 1 DDP...
  9. B

    Archived Rod and Main Bolts for 96- 12v

    I am in desperate need of one rod and one main bolt for a 96 12v. I tore it down and bought new head bolts, but had no idea the rod or main bolts would stretch when retorquing to spsc. That is all I lack before I can button up the engine and reinstall it. 96 2500 4X2 5sp stock 389K mi...
  10. B

    Engine/Transmission (1994 - 1998) Head Groves ?

    I am planning on replacing my head gasket on my 96 12v. (Due to excess crankcase pressure blowing oil out the vent above 8psi boost. It uses no oil as long as I stay below that boost pressure. I can't gripe at 400K. ) Replacing injectors and doing a valve job while I've got the head off. I...
  11. B

    96 quad cab parting / whole truck

    Roadking, What does the Banks power pac consist of and what brand 4" exhaust system? What are you asking for these parts? J Jones, North Central Texas 96 Quad cab, 2500, 4x2, Std, 3. 54, Mostly stock @ 400K, Boost and Pyro,
  12. B

    Engine/Transmission (1994 - 1998) looking for advice on getting more power

    I am planning on replacing my head gasket on my 96 12v. (Due to excess crankcase pressure blowing oil out the vent above 8psi. It uses no oil as I stay below that boost pressure. I can't gripe at 400K. ) Replacing injectors and doing a valve job while out. I ran across an article about...
  13. B

    Complete 1996 5.9

    Will be interested in complete engine. Was the engine running when it locked up? You said midsouth as location, How far from Dallas, Tx?
  14. B

    Engine/Transmission (1994 - 1998) Blowing Oil

    My 96 12v stock engine, 4sp, with 215,000 on a new short block ( all other engine compoents have 385,000 on them. Block replaced after a quick lube station left the oil plug loose. ) has taken to blowing oil out the breather tube when the boost exceeds 10psi. This is to the tune of 2 gallons in...
  15. B

    Engine/Transmission (1994 - 1998) Cruise Control Servo for 96

    My cruise servo has sprung a leak and will not hold. Does anyone know where I might find a replacement? J Jones 96, 4x2, 3. 54, 389K, EGT & Boost gages. KDP locked down, Fresh air intake, otherwise stock
Back
Top