Recent Content by CATwrench

If the evaporator isn't clogged up w/dust you might have water in the system, you could try evacuating the system and then recharging. Also check the reciever/drier.

There isn't a whole lot of difference with the swaybar removed, other than it offroads better. I took mine off and couldn't feel a big difference w/out it until slamming turns at 70+ mph. The drop brackets give more clearance for the reservoirs but still doesn't line up the endlinks correctly. I...

Mine seems to get the best mileage(empty) on the 60hp setting, never really got any better than two miles a gallon on any of the settings.

I was wondering if anyone has (mistakenly) ran their 3rd gen on red dye fuel and if it seems exactly the same. I've always heard that there's no difference but I had a friend tell me it IS substandard fuel. I am 99. 9 percent sure it's the same but was curious if anyone has used it on a...

Cheap construction, I could break the sidewall cords with my fingers, I don't know how they had the load rating that they did. I did have a set on a lighter truck and they seemed fine on it but the ones I had on my 3/4 ton road terrible, going around turns it felt like they were gonna roll out...

The cooper 315/17's seem to be a pretty good deal$$. and have the same general tread pattern as the BFG bajas(which are $450+ a piece). Was wonderin' if any of you guys have'em and if you get any wallowing while cornering? The description doesn't say anything about the sidewall construction and...

I threw my mbrp duals in the trash and got the magnaflow 5 system (turbo back), unpolished, w/o the tip. Very well designed system and fit perfecty unlike the MBRP. IMHO magnaflow makes the best exhaust systems gas or diesel.

I would be most concerned w/symptom #1, it sounds like you possibly have a bad hyd. clutch slave cylinder. I had a half ton that did the same thing since new, the service techs said there was nothing wrong w/ it until I finally replaced all the bearings in my clutch only to find out that the...

If you get the gauges from Geno's they give you excellent instructions and is very easy to complete youself. No one will get the shavings out of your manifold as good as yourself. Just take your time and follow the directions.

Amen, brother.

The service writer at Jack Powell in Escondido CA used the 35" M/t's to get out of the shudder portion of my complaint and used the "modified suspension" excuse to get out of covering my steering box. I didn't expect them to cover it anyway. They also noted my modified intake and 5" no cat...

I've had great results w/ mine. It's plenty of power on the top setting for a stock motor/drivetrain, I wouldn't want any more unless I had transmision money burning a whole in my pocket. The only problem I have had is that they sent me one for a 3. 73 rear end instead of 4. 10.

It's a very easy install and Kore's directions are pretty much idiot proof. You WILL need at least one large, and one not so large jack though. It might take a whole day if you get drunk and take an afternoon nap, but their install time is in line w/what it would take to do a "no mistake, triple...

It's awfully nice to have an 8' bed and still be able to make a decent U-turn :) . If you ditch the center seat section there is a lot of open space in the regular cabs for two people, three is of course out of the question. The cab would have to stay tighter over the long haul of abuse and...

You will get a lot of injector noise if you remove the kitty w/ a small muffler. I had the mbrp duals and wittled them down to just the muffler dumped before the axle and it sounded terrible. Ended up getting the magnaflow 5" turbo back (no cat) and couldn't recomend this system enough, $545 to...