Recent Content by Colando

Hi , Was wondering how to go about getting aluminum rims ,I have stock 16 in.steel wheels now , do I have to switch to 17 in? Can't seem to find much in 16 inch. Thanks for any help

Best AC Don't know about best driers, but I have never had any problem with Denso compressors

Before you do anything test your fuel pressure then get rid of that piece of junk lift pump that Dodge sells you. Go with a Fass or Airdog there both good and should eliminate any future lift pump problems. But while your at it Install a fuel pressure gauge!

Marsh, I went through this years ago with my truck, dealer replaced 1st lift pump with same , then dealer replaced 2nd lift pump with same, then dealer replaced 3rd lift pump with intank pump. That was worse than the others only put out 4-5 psi while running down the road. Finally installed...

I just went through this with mine, so far all i've done is tighten the screws and it has stoped the lights from leaking, carpet still dry after several rain storms, i'll try putting silicone on the screws when i have more time, if yours is coming from the back i would try a little silicone on...

Has anyone on here had any experience with the Quadzilla MM, they claim an 8 to 12 % improvement in mileage. This would be great if you could really get it, but I'm suspious of claims like this. Any thoughts? Thanks

I had the same problem with my Air Dog , pressure bounced around and got my very worried, turned out it was the sender I had purchased from Geno's 1 year ago, they sent me a new one and that corrected the problem immediately. Hope yours turns out the same way!

Thanks Matt, for the info that sure helps

It's a 97, Sorry I didn't include that.

My original ones broke after a few years use, replaced with aftermarket ones from Ebay that claimed they were much stronger than oem. They are now 5 years old and still doing fine, you might try looking there. Good luck, Joe

A friend is trying to do front wheel bearings on Toyota 4runner 2 wheel drive and can't see what holds the hub , no bearing cap, nut & cotter pin etc. any body with knowledge would be greatly appreciated. Thanks Joe:confused:

Does anyone have any info on whether it's OK to use 15w40 diesel oil in a gasser. I have a drum and would like to use it in my Jeep 4L also. :confused:

I agree a great idea, but just a reminder, be careful, anything that goes into the certer hole in the filter goes stright into the engine. Watch that plastic or tin foil sealer on your gallon oil jug.

In Tank Pump I had two stock fuel pumps replaced by dealer under warranty. When the second one failed they installed an intank pump,still under warranty, The intank pump never put out more than 7 psi at idle and dropped to 3-4 under load. Dealer told me this was normal , I finally gave up on...

I need to purchase a replacement 16 in OE. dually rim for my truck , I would like to find a used one due to cost of new but don't know if Ford or Chevy rim will work. Anyone have any past experience with this? Any help would be appreciated. Thanks