Recent Content by Cooperman

<b>Thanks to all you good folks</b>. It is looking like a bad PCM at this point. It is cheaper now to buy one than to test further at a shop - <b>THEN</b> buy one. I can run this way until fall or later, since the system stays charged to about 12 volts. I cannot see drops when running...

AOwens - thanks for the reply. I am getting a bit confused here. A "speed sensor" from the transmission (yours was corrected on a tran rebuild) should indicate rolling speed. I believe (correct me if I am wrong) that my "speed sensor" is on the diff. I get the "engine not running" whether rolling...

Thanks Moe, I am beginning to think that may the the problem, BUT, I have both Tach and Speedo. If the sensor were not working, I don't think the tach would be working either... ... , I could be wrong there. I tried disconnecting the intake air heater relays, and that did nothing either...

Thanks GAmes, but that did not work. I have a scanner now, and it indicates the engine is not running !!!!! It does not detect ANY codes. Just gets curiouser, and curiouser.

I had posted below that my 97 12v has the gen light on, and the alternator will not put out more that 11v. Two new batteries, and two new alternators in this last week. Batteries will charge to 13. 5 volts and hold. I got a scanner, and the scanner cannot detect the engine is running...

I just included all that so he could actually FIND the screw. He asked how to adjust, so does not know where the screw is located. Without working the linkage and feeling where it is, you cannot find that screw. Once you know where it is, then jamming the pedal is the way to go! Thanks for...

Three days ago, I went to town (35 mi) with no indication of trouble. When I tried to start the truck later, the batteries were completely dead. I had a truck hooked up for about half an hour before the charge allowed me to start the truck. After starting there was no electrical service...

Idle adjustment There is an idle adjustment screw at the end of the linkage. It is either viewable, or reachable, but not both at the same time. You can manually move the linkage at the front of the engine, and follow the linkage to the back. Reach in to the block in front of the brake...