Recent Content by CVonRitter

yes. that is right. .

thanks, i will give it a try. .

for the wheel hop. . i did not get wheel hop at all. . , but what should a launch at (boost) at the drag strip. . ( in two week i am going to J&H event in redding,ca to drag race and sled pull. . )

right now is going to be covered under warranty, but i am going to put it to the test in redding in two weeks. . so we will see. . but is it normal for a 450 hp truck to do this. . i have been told by many that the billet shafts are good for alot more power then i have. .

ya. . but still i have maybe 450 hp. . my truck is nothin special. . it have intake,exhaust, and a chip. . and everyone says the billit shafts are good for alot more power. . right??? also level 2 on the timing may hurt me on the dyno in what way, i am new to the diesel world in away. ...

on top of what you think of the shaft. . what do you think of my truck not running right on level 7. . ps; i have ran the wastegate in the off setting on level 3 and 5 before and it was fine and it hit 46psi. .

broken Billet intermediate shaft.. what do you think?? also smarty problem! ok. . so last saturday at left coast diesel's dyno day, i put my truck on the dyno with smarty (tnt) at level 7 with the Torque Management at 3, the Injection Timing at 2, the Rail pressure at 3, and the wastgate off. ...

4. 10 here in the bay area in ca.

my sig tells it all... . (out of the box smarty)

i would have got a ford... . not. .

also i dynoed my truck with stock fuel system and on level 9 on the out of the box smarty my fuel pressure fell off... and i do not run it above 5 for now... and just think you 2 programmer stack...

first i would get a fuel/ rail pressure gauge. . then a FASS 150/150 system it is big, but will give you room to grow. . my fass 150/150 is in the mail, will be here wed.

mine will do the RPM hang up and when i am trying to slow down, after hard take off. . and it is a auto... did it stock also... it is not that bad but i can tell it is doing it...

i have the same problem. and i also Havent had time to look at it... i will update in the next day or two...

I noticed that also...