Recent Content by David Wilson

Sometimes the fueling box and your ECM just don't communicate. It is usually caused by a faulty connection. Try checking the MAP Sensor connection, pump wire connection (if used) and the power wire connection for the box. While the condition you discribe is usually caused by the pump wire...

Tod, Sounds like you've done all the right things BUT, when you crank the engine, hold the accelerator pedal to the floor. When it starts, back off to 1500 to 1700 RPM for a few seconds or until the engine smooths out. If you don't hold the pedal to the floor, you won't have any fuel flow to the...

wyosteve. Check all of the electrical connections for the EZ and put dielectric grease on them. You are loosing the signal to the pump or ECM. Might help to secure the connections with tape or something after doing the above. A bad connection will cause your problem. Hope this helps.