Recent Content by diesellant

Yes, it seem to run ok. There is no turbo connection to the intake, and it has a miss but I think it due to being cold (about mid thirties here) and lots of smoke. Starts right up now and apps seems to work fine. The more I look at the whole project the more tempted I am to just load up the...

It fired up after I bled the injector lines. For some reason it does not like the 16 meg video. Any suggestions on how to get it uploaded?

Ready to fire it up. Pan was crushed with a gash (beat it back together,brazed it up an pur some rtv over the top for good measure. Wired it up per stick note.

Started working on an engine stand. Decided to use 2 jegs 1000 pound stands and make one cummins stand out of it. The upright need to be cut 5/16 on one side then bent plumb and welded. Later I will add the 4 swivel feet to the bottom leaving the fixed wheel bracket for a 2x4 to mount a tray to...

Found out from the electrical drawing and youtube the connector in my hand does not need to be connected to anything for the engine to run. It goes to the pcm which takes signals from the sensors on the engine and uses them to drive the instrument cluster and to regulate the shifting of the...

Thanks for the suggestions. The engine has complete wiring including the harness that goes from the ecm to the VP44. I need to get over to the bone yard and get the other plug half (engine bay side) that goes to the engine harness. Look like it has 12 pins. I read some where it has 11. Blue chip...

I have a complete 1999 24v Mexican engine that I bought from ebay to replace a 53 and need to test fire on the pallet. It is all blocked up and strapped down. What is the bare minimum wiring need to fire it. It will have some sort of pressurized fuel to the filter. Any other suggestions for...