Recent Content by Dodger2014

I installed mine. It was the Mopar kit with template. I would step down one size. I did run the screws in the plastic inserts before snapping them into the roof but some of them still turned. Had to put a little super glue to hold them. Other than that took my time and have had zero problems...

I check the drag link often on mine. Made sure that the alignment guy tightened them. I put match marks on the locking nuts to the collar. If they move I will know it.

I am having a few glitches with the 17.11.01 update. Phone sync sounds well but when I use the button on wheel to change songs it takes a few seconds or more before switching songs. Also the wrong title will be on the screen as well. If I reset it will it help or not?

Maybe not at cummins but at a dealer for service or warranty work. Bought mine used with 31k on it.

Mine did the same thing. I was missing 2 of the 6mm hex screws and 1 was backed out about a 16th. Went to ace hardware and bought all new screws and loctite. This happened around 64k have 72k and all is ok. Don’t know how this happened and thankfully none of the screws that came out caused any...

I put 295/75-18 on mine and a week later put leveling kit on. Had it aligned to Thuren specs and the Nitto Terra Grappler G2’s are wearing very well! Have over 20k on them and can see very little wear and are very quiet. I Have rotated them twice so far. Don’t know about snow and ice too much...

Oops! My aging eyes didn’t pick the T6. Yea, mine was T4. Sorry.

Picked up 3 gallons at Wally World for 12.99 each.

Mine did update as well. NO CarPlay. Guess the older units don’t have the hardware to handle it.

I put 295/70-18 on mine. They are Nitto Terra Grappler G2. Low low noise. Wear great since I had the front end aligned to the Thuren leveling kit specs. Mileage went down about 1-1.5 mpg. I don't have my foot in it a lot these days though! need to update my sig!

Watched the ram man videos. I wonder if the factory bearings are rubber sealed or shielded? Rubber seal really can't be serviced but the shielded bearings have a metal "cap" that has small holes to let grease from the bearing cap work in while they are turning. These caps can be popped off on...

My 2014 does same thing.

I have used the Monomax on previous rams ive owned. But so far they do NOT make any Monomax for 2014 on up. They just make an oem type replacement.

just drove from Georgia to east Texas for xmas. About 15 hour drive. To keep busy I tried to notice any ram trucks on the road. Saw a lot of 3500 dwr hauling 3 car wedges, rv, etc. Like seeing that they are used for work! Even seeing them used for ambulances more and more where I live and...

Replaced pump the other night and found that the leak WAS coming from the weep hole! Flushed system with distilled water. I actually honed the face where the water pump mates to a smooth finish. Also honed the face or mating surface of the water pump to get the high spots off from there. Then I...