Recent Content by DSchell

My cylinder head needed some machining and I decided that the shop should also cut some o-ring grooves while they're at it. I gave 'm the wire(. 041) that I'm gonna install and they cut the grooves. I also gave 'm the depth I need. How should the wire fit in the groove, should I be able to...

I slammed the old ones out with a socket. For the new ones I heated the rods in the oven, and then I tapped the bushings in with a nylon tool. But I think you're right; if they need to be honed then it was better to let the machine shop do the entire job. To much hassle and to high of a risk...

Hi Guys, I'm rebuilding a '95 and I've also got some new piston pin bushings for it. My problem now is that the inside diameter of these bushings is way smaller then the pins outside diameter. The pin is 40 mm (1. 575") and the bushing is 39. 6 mm (1. 56). I already put a few bushings in the...

Thanks!!! Thanks for your replies and the welcome! It's just that... ... it doesn't feel right. I'm not sure if I explained the situation right the first time: I have the AFC housing off and the torqueplate removed. I'm now looking into the governor. The shut off lever is up. When I pull...

Hi guys, First post here, would like to start by saying that this site ROCKS! I really enjoy reading al the posts and to learn from them. While I was reading about the P7100 tweaks I was playing with my own 160 pump to see where all the stuff is located and to see how they work. It's from a...