Recent Content by dsldude

I wanted to update this post for any others who might have the cut out and rattle. After my last post it still has issues i realized. I finally bought the hptuners. Removed all limiters that would cause antly cutting out. All good now. I adjusted a lot of other factors and completely got...

I pulled my dinger first thing like the video shows. Have done it with a few of my cars. I hate dinging. Pretty easy to do

Possibly rail pressure sensor wigging out?

Are you positive there are no boost leaks? Did you pressurize and check for bubbles or put smoke through the intake? Hit all connectors that you can with some dielectric grease. Monitor with odb and see what it's doing. Odb testers are cheap

I liked my ebc green stuff pads. They stopped much quicker than the stock ones.

Codes?

Usually not the sensor. Probably something else going on What's the exact code? Could be an intake/boost leak, injector leaking, or grid heater issue from my understanding

You need the whole kit. Pump, pulley, bracket, and resevoir. Could find cheap on ebay too off an 09 or 10 truck. The whole kit new is 500 to 600 bucks. Can find used for around 100. Get some pics if you go to ebay though.

I call bs. You should send in for analysis and see if its bad . Just a ploy to make you buy more. Ill take it all! I'm in Colorado. How much to ship?

In the end, it seems running out without the fca plugged in damaged the rail pressure sensor. This was causing excessive noise, smoke, and rattle. Put new in and man, she runs nice! The smaller turbo housing helped with the cutting out and surging, but it is still there when i hammer on it. I...

I want to say it's around 1800 stall?

I have been running 50wt in my t case for about 6000 miles now. It slowed the leak down at the front trans to t case seal to almost nothing. Runs a bit quieter now too. Im sold on this. A t case is just a gear box really. I would never run ATF in any gear box so why this? No clutches. ATF is a...

This has been the case for a while on this truck since I had the transmission replaced. Basically if I backup to a small object, say a 2x4, hill, or a small curb, let the truck stop on it and try to power over it in reverse, it will not go. It spools, smokes, etc, but wont power over the object. It...

You should be able to click on it and expand it.