Recent Content by FGreiss

Sorry Wayne I've been slack about personal info and usually start out a thread with 99 2500 TD. You should now be able to view truck info. I bought this truck not knowing all the computer problems ,wiring. This was a truck that was road hard. and dressed up for sale. I found Flag ship one at...

Searching for PCM for my truck and wanting feed back on a company Flag Ship One any comments about their products also looking for OEM battery cable and starter wiring harness. Thanks!

Thanks JR will do

Noticed alt. not chg. over 11.28 volts replaced Alt. no change, batteries fully charged. Also trans. no bottom end will not lock into over drive. I have already had to deal with interference due to alt. Had My buddy check power train but computer not able to read transmission shifting. At dead...

Need to go back and check everyone's advice. Thank you! will get back to let you all know my results.

To BOB4x4 I Don't Drive this Truck everyday. 1st noticed running in the 300 to 700 range. Bought a 20 ft. Round nose car hauler and ran it ran 1000 to 1200 warm day. No real cargo weight . Had radiator Flushed needed to be done . ? inter cooler, Radiator? Let me Know Thanks!

I Have a "99 24v 190,000 with Pyrometer reading 1200 degree's. Running temp of motor around 200 degree's. Load of fresh cut oak. After market repair manual only talk's about low or restricted air flow, check or replace air filter. My air filter is K&M Please help.

Thanks AKorn I did not think about the fluid level could be to high nor breather tube clogged. I will check them both. And let you know! Happy Trails

Thanks for the info need more input. The fix is still in the dark.

Thanks for the info, Yes it has a two piece axle on passenger side. I do relize that it has to be torn down to replace or fix problem but want it right! I still am wanting feed back on accordian seal as well a clean fix. Thanks Fgreiss.

I have a '99 2500 170,000 plus miles. Dana 60. I had a friend of mine whom is normaly very good at fixing anything, replace a front axle on right and bearings and seals through out. After a short time the right tube has begun to leak . He warned me that it might because how hard it was to set...