Recent Content by fluemasterjr

i have an 86 6. 2 with a built with a 92 block not sure what else is done to it. Its was my first diesel and i love it 19mpg i have to say for a non turbo v8 diesel that thing has some snap and for low end torque and traction it walks over my 03 but as for top end it is gutless. when i have...

my wouldn't be caught dead driving a power stroke

the black boot would be more her.

does anyone have any good ideas on modifying the clutch petal so that a shorter person could reach it my wife is 5'1'' and has a hard time driving my 03 ctd. she can reach the break and the throttle fine but the clutch just has to much movement for her to drive comfortably. thanks.

I replaced my factory lights with the recon kit due to a leaking roof. that was about 2 years ago and now have 2 light that are burnt out and 1 that flashes on and off. Any one know where to get led's?? i think it is a 196 bulb my locale part stores cant get them.

Gharman i would love to see a pic of this setup when you get them

"Back in the early 1980's, tests were conducted to discover which kind of wood created the most creosote in a regular "open" fireplace. The results were surprising. Contrary to popular opinion, the hardwood's, like oak and madrone, created MORE creosote than the softwoods, like fir and pine. The...

"I liked the method that a nobour imployed years ago. The wood stove was 45 Gal drum and had it full of wood ( dry) and through in a gal on used diesel oil and some gas. It roared for about 10 mins and then calmed down. Not to good for the enviroment but cleaned out the flu. Ahhh George,what a...

I have always used never seize on my balls but if your not careful it makes an awful mess. I always get it on my pant legs.

i have had my juice with attitude now for about three weeks and love it but the last couple of mornings i have had some trouble with it. the out side temp is 20f and the motor has warmed up to 180s but when i set it to level 5 and floor it, it will go for about 2 sec and then the motor will cut...

I purchased an 08 Gmc 4500 up fitted with a utilamaster service body and would not recommend them at all. I have had nothing but trouble with it from the front end to the motor not starting the headlights wouldn't work and i can't keep a pinion seal in the rearend it has been to 4 shops now and...