Recent Content by gpintler

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff
  1. gpintler

    Is there a Horn relay in my truck ?

    I have found that the Horn relay is stuck on. I can't find the horn relay, but I am looking for this small 1 inch cube. Now I am thinking that it is part of the Front Control Module. Can somebody tell me where the the FCM is located in my truck. (2004 4door 8ft box 4X4 SRW)
  2. gpintler

    Is there a Horn relay in my truck ?

    I think I found my problem. I do not drive my truck much in the winter. Last time I drove it was hunting [10-23-24]. I went to go start it today, and it was dead. 1 battery showing 8.9 volts and the other showing 9.1 volts. This could be the cause of the problem. The Mopar batteries were...
  3. gpintler

    Is there a Horn relay in my truck ?

    ok more details to help you guys help me -- 2004 2500. My horn beeped 4 time with in 20 minutes. I thought it was 1 of my friends installing his air horn kit. Walked out of the house, the truck beep 1 more time and then locked on. I than opened the hood and pulled the fuse. It was been cold...
  4. gpintler

    Is there a Horn relay in my truck ?

    My horn started going off the other day. I pulled the fuse to get it to turn off. Because I am an (old) guy I thought that the relay has gone bad, but when I pull the cover to the fuse box, I can not find a relay labeled HORN. I did a bit of reading an found somethings about a FCM module...
  5. gpintler

    The Vacuum Pump

    I am working on my 04 The Vacuum Pump is located on the right side [sitting in the drivers seat]of the engine compartment, close to the fire wall. A small line goes to a T center of the fire wall, then continues to something under the battery box. 1] What is connected to vacuum in the center ...
  6. gpintler

    Help with an electrical connector

    Thank you Diesel85 -- but I need the the opposite of the links that you sent me to. The Pic above is male pins in a female housing. That is what I need. I would like to plug something into the factory wiring harness. The links you suggested are the connections on the the wiring harness. thank...
  7. gpintler

    Help with an electrical connector

    I hate cutting my wiring harness so here we go. The license plate light bulb plugs into a plastic fixture. That fixture plugs into the, Well I will call it the Bumper harness. I would like to find a plug that will plug into the bumper harness that just has 2 wires coming out of it. so it is...
  8. gpintler

    Bed size matters.

    Out west where just about 1/3 of all trucks carry a 4 wheeler in the summer, 8 foot beads are the standard. trying to carry your Honda in a 6 foot box can have some problems. My truck does have a bit of storage under the rear seat, but I put a nice tool box in the bed and 6' 6'' to park my...
  9. gpintler

    Help with Bed Sizes

    I was abe to find a color matched ARE for $400 Thank you for your help
  10. gpintler

    Help with Bed Sizes

    I am looking to buy a canopy for my 2004 long bed 2500. The question is Will a gen 2 canopy fit my gen 3 bed ? Are the bed dimensions the same for Gen 2 and Gen 3 long beds ? Thanks
  11. gpintler

    Dodge 2500 Grampa Edition

    If you do a search on my name, you will find the thread about my new head unit. One of the apps in the unit is a usb camera input and the app has a shock setting. Now I don't use that app because before I did the stereo upgrade I already had a simple but good Forward Looking camera installed. I...
  12. gpintler

    Dodge 2500 Grampa Edition

    Yes 4X4 forward looking camera rear camera in the handle stereo head unit with all the options FRS/GMRS radio rear flood lights [connecting trailers in the dark] Firestone Airbags all controlled by no switches on the dash
  13. gpintler

    Dodge 2500 Grampa Edition

    I finally answered all thier question with "Grampa Edition" While camping the last weekend I had 4 different guys tell me I had a nice older Dodge. Then I got all the same questions. Why have you not lifted it? What --You have no tuner! You really need bigger tires! You really need a SUB for...
  14. gpintler

    Needed More Small Parts

    I would like to get some help with part numbers and a source for these items 1] A bolt and a pin(?) that connects the 2 halves of the rear calipers together. has a rubber dustcover on it. 2 sets are needed per rear wheel. Sorry I don't know how else to describe it. 2] Those washer clipy...
Back
Top