Recent Content by jdbecker2

That zerk looks a lot different than what's on their website :confused: Lower Ball Joint- Carli

Butterman, it might be wise to check the dealer price compared to your friendly Cummins distributor... the dealer tends to be more expensive, and often they have no clue about what you're talking about

Where at in Illinois? I have an 06 also that had a coolant leak around the exhaust manifold. Mine was cured just by tightening up the clamps. There is a recent thread about a cummins part number for a better fix. I'll see if I can find it. Looks like someone beat me to it, but here is the...

Wingate, it shifts through all the gears. I'm almost positive its not in the transmission. Seems like something in the bell housing as you stated. It'll move about a foot, and then act like its in neutral. It doesn't seems like the clutch is engaging all the way. Hopefully they will tear it...

The truck will move but only about 2 feet, then it stops. The G-56 doesn't look like fun without a lift... Thanks for the responses guys!

I've been going to school at WTAMU in Canyon, Texas. Just got done with finals and was planning on heading home to Illinois to get the corn out (another story). When I started the truck it sounded like something caught funny, but I didn't think much about it. About half an hour later we went to...

Did you get them locally or go the online route?

Wow. . those are nice lookin rims! Really brings everything together!

I am not positive, however when I got my truck reflashed for the long crank issue, there was also a note that the flash fixed the tach also. I didn't notice the problem before (doesn't mean it wasn't there) but it's certainly not present now.

JSzewczyk, PM sent

p2509 is powerdown data loss error... Sounds like a battery problem. . Maybe this is way you can't connect your smarty? Possible Causes POOR CONNECTIONS AT THE BATTERIES LOW BATTERY VOLTAGE OPEN FUSED B+ TO ECM OPEN GROUND CIRCUIT BATTERY + SHORTED TO OTHER CIRCUITS RETURN CIRCUIT...

Jim, thank you very much... One of these days we need to talk about a pacbrake purchase :)

When I was removing the the hub today, the bearing separated in half... Luckily, everything else broke loose at the same time. Is it possible to press the bearing back together, or will I be calling skf tomorrow? Thanks, Jake

Thank you for all the replies. The joints all seem to be good. Inferno, that's what I was thinking about last night. I took the truck for a short drive around the block today and when turning out of the driveway it almost seemed like it was in 4 wheel drive :eek: Does anyone know the size of...

I've been back down in Texas for school for about a month now. When I was driving home tonight, I noticed a vibration when I let off the accelerator, it was gone when at a constant speed or accelerating. In the short time that I could look at it, it didn't seem to matter if the truck was in gear...