Recent Content by Jimmy’s

Odd the U0101 cleared Maybe it was present as ECU and TCM are not perfectly communicating That is the first time I have got 706. Maybe it comes from the U0101 It has been disconnected and cleaned with c130 and c210 connectors. All appeared fine. Before I start back pro probing, as i find it...

Still stuck, no start. No PRND321 No communication through canbus. Auto Enginuity on wireless finds 706 100 121 Dash displays h13544 when reset odo depressed All connections and grounds checked and re checked. Added extra ground straps Any thoughts

I have a new gasket which I hope clears the 607 The U0101 is the troubling one. I have cleaned all grounds, dielectric Maybe I missed a ground somewhere. This all started with the )bolt( a few weeks later it died. Cleaned terminals etc. Ran fine then again didn’t start. Replaced fan and all was...

Back from rebuilders Transmission seems to be an issue too I have tried the Powertrain verification test many times After a drive cycle still get P0607, and after two cycles the. U0101 Back probing, seem to have enough signal to terminal 19 Guess it TCM off to rebuilders

Other codes U0100 U0141 C2202 C2206 And some AC as it is unplugged

Got it home Guess I will remove the TIPM and ECM Send em to the rebuilders and hope for the best Then, i will spend some time looking at wiring. Time to test my new short finder. I wish my AutoEnginuity would dig deeper into the trans. As I drained the fluid the other day, was gonna replace...

I replaced fan clutch, batteries, cleaned all terminals, connections. Dielectric etc Had just replaced the alternator last fall It’s been running great till a month ago, and with no codes until it died

The reoccurring code is P0472 I only got the 607 once The 700 a couple times The first time it shut down, with the )lightning( I shut it off, took key out. Key on, cycled fuel peddle slowly. Started. No issues for weeks. Then it just would not restart one day, again after it got to temp. The...

My suspicion is corroded bits, cleaned most terminals. Still having issues, like stalling and now sputtering when gets to temperature. Any thoughts? Thanks TDR