Recent Content by JosephKing

Oh dang you are right, Thats not cheap at all. When I looked at the sight I did see one end only at 40.00 dollars.

I looked at the Mevotech, that looks like a decent setup, I’ll reach out to them and get more information. Has anyone modified the tie rods with the Luke link setup? Not finding much on feedback on the performance side. I did reach out to them and asked if the can make the modification and send...

I looked at the Apex and reading the specs on it, it looks to be a decent grade of mineral, and what concerns me is the cost being much cheaper that other brands.

I’m sure this isn’t the first time this topic has been discussed. I did some searching before posting here. I’m at the point again where I need to replace Tie rods and would like to find some that would hold up to the beating these trucks put them through. After searching around the web I came...

2005 Dodge

Calendar looks amazing. Congrats

has anyone ever experienced motor mount wearing Down and metal To metal causing a vibration while it’s under pressure from torque Maybe at that speed?

Thanks Bruce for your feed back.its sounding like my next option may be to look at that gear set and bearings in the rear end. The bearing in the front are not the cause,I’ve inspected and repacked.

I doesn't have the carrier Bearing, its a short bed Thanks for the reply

Greetings Fellow Diesel owners, I’m writing a post to get some feed back from all of you on an issue that just doesn’t seem to be going away. I Drive a 2005 -2500 4x4 I’m have a rumbling sound between 66 and 74 that is a rolling rumble sound. If I keep it below and above the given numbers, its...

Camping ⛺️

Greeting to all, (newbie here to the forum) It’s been a while since I did this Lab test on my truck and wanted to share this. I did some research on the forum and wasn’t able to find any open chats about anyone doing the testing. I do not recall where I found the information to send my oil off...

2005 Dodge 2500 Cummins 5.9

2005 Dodge 2500 Cummins 5.9