Here I am

Recent Content by Jpolk1

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff
  1. J

    2nd Gen Non-Engine/Transmission Drive shaft question

    I’ve removed my drive shaft from my 2000 ¾ 4WD to replace the center U-joint “for the second time” !! Could the center bearing be bad?” It feels very smooth and does not seem to be bad. I did not find any real inspection criteria in the shop manual for checking it. Jim
  2. J

    2nd Gen Non-Engine/Transmission How to lower bed height

    Thanks for all that replyed. Does anyone have a good lead on the airbags and about how much they would be? If I use airbags, will they replace the block between the springs and axle? Jim
  3. J

    2nd Gen Non-Engine/Transmission How to lower bed height

    I’m looking to lower the height of my 2000 2500 4WD to prevent anymore contacts with it and my goose neck dump trailer. I did see where dodge had a kit to lower the rear spring stack, but when I asked about it at my local dealer I was told it was no longer available. Any suggestions? Thanks, Jim
  4. J

    2nd Gen Non-Engine/Transmission Driveline Vibration...

    I am in the middle of somewhat the same stick. . I developed a well what would sound like a exhaust leak coming i from a trip at around 65 MPH. As I came in off the highway and at around 10-15 MPH my truck started to vibrate like a rig that had aggressive mudders on it. I thought I may have a...
See more
Back
Top