Recent Content by jroyster06

I wanna do something very simular just looking to lean tawrds white and black rather than white and chrome

Well guys i have been outta here for awhile but now Im back. I sold my 3rd gen and just picked up a 2011 2500 4x4 8ft bed ST last week. NO, sorry no deletes yet... . Not for 5yrs/100k. I just started getting nervous about the whole 3rd gen injector thing as i was nearing 100k on it and really...

I may just have to make a short drive to Richmond!

This is from another forum but a great write up none the less How to fix where your air goes. (HVAC) - Dodge Cummins Diesel Forum

does anyone know where i can buy all new blend doors. Pulling the dash is no big deal and i would much rather spend 4 hours doing it right than 2 hours cutting into the box and cutting corners.

What i read was something about a connection near the TPM. Not sure as to any more detail.

I have optima red tops. I LOVE LOVE LOVE THEM!!! I can run my Radio w. amp and subs all night, hooked up to my horse trailer using truck to light interior all night long with no problems. I also like them for the simple fact that they are sealed which means you will never have to clean a...

Like i said before im not sure its the blend doors i think it may be electrical. Sometimes they work great sometimes they dont.

:-{} I know i know. I am having blend door issues. I know that a lot of them strip on the axle but i dont think mine are. My issue is sporadic. Sometimes they work great, sometimes not. I seem to remember reading recently maybe in TDR mag or somewhere in forums about it being an electrical...

Ok ill see what i can work up and see if i can get ahold of his username or email. Thanks guys

Prarie Dog: The color seems slightly off not bad at all. Its a tad bit lighter but not enough to notice unless your looking at it. Im very impressed with it myself. FDrake: It took about 4 hours with basic hand tools. The only power tool i used was my screw gun. I highly recommend one even a...

I did pull the dash out and do it on the bench. Look at pic #3. The reason why i left the wiring is because of an aftermarket alarm/remote start that was in the truck. I did that instead of removing all of the connections that were going through the fire wall. It was quicker for me to do it this...

I would do a write up if someone local needs help doing it. I would take more pictures. Im afraid if i did a write up now i would miss too many critical points. Its actually very straight forward.

I would have done a write up but it would of ended up way too long. Its simple and straight forward. I bought my dash from The dealership for 622! Fitment was absolutely perfect. This dash is made by a different manufacturer than original and it is also made out of better thicker material. Heres...

1500 and 1600 rpms witha load is low IMO. Sounds like you may be lugging it.