Recent Content by JWMiller

Thank you for the reply rfitzgarrald, but that would not stop a push start.

My son has a 2007 2500 4X4 6.7 G56 six speed. He recently stopped at a restaurant to eat and when he returned to the vehicle it would not crank over. Does not even try to kick starter solenoid. All fuses seam to be OK. All lights on dash came on with key (normal) radio on and windows work. Tried...

Update: Had a chance to play with mine. I have an 07.5 G56 trans, found the green wire and grounded it and it works like a charm! It is VERY tight up there adding to the wire. Thanks to all who helped me on this.

So how can I find out for sure which pin to ground, and after I do will all years let the feature be enabled? I want this for cool-down at times when pulling my 40' 5th wheel.

The Dealer said some could be and some couldn't. I was thinking a certain pin had to be grounded on the ECM to let the feature be enabled.

07 Quad Cab 6.7 6 speed manual I asked the dealer to turn mine on and they said they couldn't. Anyone know why?

Anyone know where I can obtain metal fittings threaded one end and fit onto inlet-outlet of 07-09 stock auto transmission oil cooler?

Any one know where I can obtain metal inlet-outlet fittings to plug on to the stock cooler?

Ron, Did the Fast coolers actually work or prolong the temp in the trans? I am looking at doing this with the Trans-cool or if I could find a donor pickup with an auto, use an electric pump and put on all the stock trans cooler, lines, fittings and hoses to make it look factory.

Pictured below 2007 2500 6.7 G56 Pickup and trailer 2019 Montana 5th weighed in at 22,500. I also have an 01 2500 QC LB with the NV5400 and the cast iron case keeps the case from growing (expanding) in the heat. I hear the G56 aluminum case expands with heat and bearings loose there preload. If...

Pictured below 2007 2500 6.7 G56 Pickup and trailer 2019 Montana 5th weighed in at 22,500. I also have an 01 2500 QC LB with the NV5400 and the cast iron case keeps the case from growing (expanding) in the heat. I hear the G56 aluminum case expands with heat and bearings loose there preload. If...

Can anyone rate or provide information on how well the Trans-Cool manual transmission coolers, Geno's Garage sells for the G56 six speed, work? I would like specifics on temperature difference (before and after) installation. Do they cool it or just prolong the temperature? On a pull? On the...

This temperature is on a G56 six speed manual. Since this picture was taken I have pulled over some passes when the temperature exceeded 225 in 4th gear. Has anyone used a set of Trans-Cool coolers from Geno's? I would like to see some ratings and reviews.

The sending unit is in the bottom of the PTO cover on left side. Temp was as high as 210. This was the first time pulling since installing the gauge.

So how hot is to hot? This was taken pulling my 37 ft. 5th wheeler at 65 MPH at 75 degrees. I am using 50wt Mobile Synthetic in my G56.