Recent Content by KennethCrosby

New One for everyone. Body work on a 2003 Dually 3500, I need to replace both side fenders and mud-guards underneath. Does anyone have an Idea, where i can get some quality but inexpensive side fenders from? Also, knowledge on the cost of all these small accessories that go with it.

I have the same year vehicle as u '03 Dodge, and the problem is your lift pump on your truck. I had the injector problems and it cost me, and then a week later the lift pump went out on me. So replace your lift pump immediately, its much cheaper.

After 5 days of waiting for a entire new driveshaft to arrive, it has been discovered, the U-joint on the second driveshaft near the center bearing went bad. I kept my old driveshaft, and plan to have the entire driveshaft redone or modified.

MMeier With some of the things i do with this truck, I really think, I would Destroy the one piece driveshaft. I power-torque my truck, and can roast my tires in 2nd gear, sitting in place. Its been about 5 yrs since that last one, but I get happy sometimes too.

Could anyone share there twin turbo experience with me?

LOLOL, Bob I had to wait til christmas passed, too keep the wife from barking :-{} at me about money. U know the drill. :-laf:{

You are right Jim, It wasn't the rotors, its the driveshaft. I changed my rotors and brakes in the back anyhow, and My truck almost stops on a dime now. but i am not happy about the manufactures not having recalls on the driveshafts, and i know if they did, it would cost them millions, each...

Thanks, I knew what it was, but kept wanting it to be something else, but when i took it into the dealership, and told them what was wrong, and my assessment, then they took my truck to the back parking lot and never brought it inside. But listen to what i said it was, and ordered a entire...

2003 dodge diesel 3500 4x4 cummins stock turbo news flash!!!!! :--)******LATEST NEWS FLASH:*******:--) MY DODGE RAM 3500 :D PULLED A 2009 TWIN TURBO FORD F350 :eek: OUT OF A DITCH ABOUT A MONTH AGO. THE ENTIRE PASSENGER SIDE FOR BURIED DOWN TO ITS AXLES. A CHAIN WAS HOOKED TO THE FRAME OF...

Next, I am looking into investing into a twin-turbo set-up for my truck. So, can i get any good suggestions? As well as, fuel/water separator?

Thank You everyone, I talked to a diesel mechanic, that lives up the road from me, and we looked under my truck. Knowing that I have to get my rotors changed (due to bad wear... . you can see the bad wear in the rotors), that is causing the vibrations in the back-end. The Diff. Seal is...

I have a dodge truck (2003, turbo diesel 24v HO, 4. 10 Gears, 4x4). This is my problem, I have had the U-joint changed out about 5 times now, and after 23k miles the back end is shaking again when i slow down between 20-5 mph and then it stops. I checked the bolts which holds the...

I have a dodge truck (2003, turbo diesel 24v HO, 4.10 Gears, 4x4). This is my problem, I have had the U-joint changed out about 5 times now, and after 23k miles the back end is shaking again when i slow down between 20-5 mph and then it stops. I checked the bolts which holds the drive-shaft...

I have a dodge truck (2003, turbo diesel 24v HO, 4. 10 Gears, 4x4). This is my problem, I have had the U-joint changed out about 5 times now, and after 23k miles the back end is shaking again when i slow down between 20-5 mph and then it stops. I checked the bolts which holds the...

I have a good Idea of what this is, but, Landmark Dodge names it : Service/Drain crankcase breather bottle. Is this the oil pan, and changing oil?