Recent Content by KJugle

To all I am having O2 sensor fault. Right now Dealer says O2 sensors are backordered across the country. Not trying to fix myself since this happened less then 12 months ago and the dealer fixed it initially and now it is covered under warranty. I have tried aftermarket O2 sensor and it did not...

It is a 2009

All right folks here is my problem. truck is throwing P0031. Dealer validated it was sensor (flopped with down stream and got P0037 indicating it was sensor) . Replaced with aftermarket Denso sensor didn't work, bought OEM sensor and replaced sensor. Cleared code and came back within 1/2 mile...

Blackstone suggested oil additive. I am not paying for it so either the dealer is giving it for free, Valvoline changed or something is wearing in the engine. Questions are out to Valvoline and Cummins. kjugle

Question on oil and oil analysis. I have been doing this every oil change (primarily to monitor fuel in oil). I started November 2009 and always use Valvoline Blue HD, dealer installed. Starting with February 2012 the titanium level went from 0 to 24-25, the implication is that an oil...

Had to replace the universal joints on the front axels (2009, 48K miles) and drivers side was long gone, passenger bad shape. They were replaced with U-joints with grease fittings. The question is how often?. Type of Grease? This is a daily drive, NE about 23K per year. Thanks

Had to replace the universal joints on the front axels (2009, 48K miles) and drivers side was long gone, passenger bad shape. They were replaced with U-joints with grease fittings. The question is how often?. Type of Grease? This is a daily drive, NE about 23K per year. Thanks

Harvey Pulled the codes with a scanner. P1776. Solenoid switch valve Under that code is the following information (calculated load 35 percent), (coolant temp 185) (engine rpm 1484) (speed 30 mph). Kip

Harvey Thanks I will let u know. It will be a couple of days. Cell coverage will sketchy kip

Harvey The truck operated fine at speed. No trailer. The engine was at about 2100 rpm. It was only after we stopped at a light that the gear indictor said it was in fourth like I had manually taking it out of over drive. I drove a couple of miles at about 20 mph and the. Rpm were 1600. I tried...

Just made a 19 hour hop and at the end the transmission went into forth and would not stay in drive. I made two previous stops no issues. The last six hours was at 82 mph in Oklahoma. The truck has no adds or deletes, no codes or warnings. I shut it down for ten min and restarted and seems to be...

Two Rules #1 dont allow her to look over your shoulder while you give marriage advice to your favorite truck advice site #2 Get used to "I'm Sorry", "I didnt mean it that way", and the obligatory "Yes Dear" After 19 years you would think that the advice would be better but every day...

New 2009, 2500, picked up Thanksgiving week. Still on the honeymoon no real concerns yet. I have noticed now that it cold that the transmission wont shift into OD until 3-5 miles down the road. looks like I am in 5th. 2000 RPM at 50 mph. Not sure if this is normal to help the system warm up or flaky...