Recent Content by krazy

Jr I've never reset it and I was saying on another post that if it is ecm not to replace it just relay it of the injector pump I'm not sure about that. If u could post how to reset apps I would appreciate it I'm gonna redo all my grounds change the factory lift pump relay and reset the ecm and...

I will try to reset it I've read on another site to just pick the signal for the pump from the injector pump but I'm confused because my lift pump is working when running to have 15psi of pressure before injector pump

OK new news fuel pressure before the injector pump when running is 14-17 when I bump the starter the relay for my airdog 150 pump just clicks and doesn't run the pump I can take my scanner and turn pump on and cycle grid heaters and wait to start light all works properly with the scanner but...

No fast idle the main question I had will as blown wait to start bulb cause the fuel pump not to cycle

It turns over for about 10 secs before it starts since light or pump hasn't been coming on. But when it starts no miss check engine light and plenty of power

I'm not sure if it comes on if I bump it or not the truck runs fine just harder to start in the cold now

I checked my cluster and that's the only light that don't come on but no codes. I wasnt sure if that powers fuel pump for them couple of secs or not

Its 99 dodge 3500

I think my wait to start light has blown but will that cause the fuel pump not to cycle on first start. My grid heater is working because you can watch the volts drop and pick back up