Recent Content by Kyle9611

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff
  1. K

    2nd Gen Non-Engine/Transmission 2001 Dodge Ram 2500 6 speed engine stalls when stopping

    Was just able to pull my codes on the truck I've got p0216 injection pump timing and p0122 tps
  2. K

    2nd Gen Non-Engine/Transmission 2001 Dodge Ram 2500 6 speed engine stalls when stopping

    It's a fass 220 not sure where it's reading from. I have a edge juice with attitude programmer. Also not sure if the fass is adjustable
  3. K

    2nd Gen Non-Engine/Transmission 2001 Dodge Ram 2500 6 speed engine stalls when stopping

    It spools the turbo well I've seen about 40 psi before it starts backing power off I've got boost gauge and egt gauge
  4. K

    2nd Gen Non-Engine/Transmission 2001 Dodge Ram 2500 6 speed engine stalls when stopping

    According to the programmer it runs about 30 psi at idle. And around 20 at WOT
  5. K

    Engine/Transmission (1998.5 - 2002) 2001 Dodge Ram 2500 dies when clutch is pressed

    2001 Dodge Ram 2500 6 speed engine stalls when stopping2001 cummins 5.9 HO 6speed truck has a weak start but starts every time push in your clutch put it in gear and start to drive down the road runs and shifts fine through all gears coming to a stop light if you hold your clutch down to attempt...
  6. K

    2nd Gen Non-Engine/Transmission 2001 Dodge Ram 2500 6 speed engine stalls when stopping

    2001 cummins 5.9 HO 6speed truck has a weak start but starts every time push in your clutch put it in gear and start to drive down the road runs and shifts fine through all gears coming to a stop light if you hold your clutch down to attempt to stop the truck gets an erratic idle and then dies...
See more
Back
Top