Recent Content by Lil evil

Update.. Put the 2 wires together..no luck Checked wires with voltage meter..no voltage Traced wires to the TIPM..appeared good.. pulled out where it plugs into TIPM appeared clean and prongs looked good.. Guess tomorrow ill check if there us any voltage coming out of where it plugs into TIPM...

Ill connect them..if i still hsve a light ill know its in the TIPM

So if i connected the two wires that should shut light off in theroy?

Good info..thx

Found a break in wire right at tve plug (where it goes into the sensor) gonna try and sodder a new wire to it..both wires are currently just cut and i still get light

I tried looping the connections together first..so i doubt i even have a good connection in the wiring..prob a bad wire somewhere.. i wasnt even getting any power from any of the two leads on the connector

06 ram 2500 Washer fluid light always on Sensor..REPLACED IT WITH MOPAR SENSOR fluid..tried em all Sensor, tried to bypass by connecting 2 Probes together Tried sensor in all positions, lock tab up, down, to the sides Tried connecting plug connections to ground and positive ANY SUGGESTIONS...

Not pushing pedal at all.. grid heater works..but the smoke is minimal

K..thx will try that

The last 2 cold starts only emitted a puf of black..barely could see it

06 cummins... bought used.. had it 45 days, never smoked. Til other day.. 144k miles.. new injectors at 130k bosch brand (have reciept from shop) started to run stanadyne (lube formula) since april1st.. (day i bought it) starts, and idles fine.. power seems good. Great mpg 16.4 in town. Stock...