Recent Content by M1DNYT3 H4UL3R

So it finally threw a code that told me the turbo is not spooling or responding quick enough. So now I will rebuild the turbo again. No more cheap eBay parts for me. I will let you know if it works.

Well it is not the MAP sensor.

The turbo has been removed at least 5 times. Trust me when I say it is clean. The fins have been set and reset several times. The actuator has been set with a Snap-On scanner. This seems to be an electrical issue. A sensor is acting really strange. What sensors act with the actuator? You can...

Ok did a swap out on the whole throttle pedal assembly from another similar truck. Still the same issue. I hooked up a blue tooth obd reader and looked at some of the sensors. Everything looks fine accept what is called the turbo pressure control. It was bouncing all over the place from almost...

I have a way to do all of that With my Torque ap on my phone. This is my next step to see if I can monitor all of the temps. On the above question, what do you mean TPS? I'm horrible at acronyms.

I have also reflashed the computer. Still does it. You can tell it is the EB because the turbo pressure immediately goes to zero when it happens.

My fuel pressure is fine. I have the high pressure gauge on my tuner. I have cleaned and checked the batteries, checked the wiring and made sure that they are fully plugged in. I have unhooked the batteries and let it set to see if it might reset itself. Still nothing. It will run fine until it...

The fuel filter has about 8000 miles on it. The batteries are about 4 year's old. They still have a good charge . Here is a little more to the story. When we decided that the actuator was the issue, we pinned open the nozzle and unplugged the actuator. Other than some turbo lag, truck ran fine...

Sorry to be long winded but there is al going on here. 2011 Ram 3500 6.7 deleted. New parts list that were installed: Turbo was recently rebuilt with all new bearings, seals a ND bushings, nozzle was replaced, new VGT actuator that was installed with an Snap-On scanner. My truck has been...