Recent Content by McCoyJ

Thank you i finally solved it. when i replaced the vss i installed it correctly and when the mechanic checked it he said i had it in wrong, which i had it in correct. So i listened to him and left it. Today i noticed that and seeing the off centerness of it, which made since because earlier i...

def. appropiate. The shop is located off of country club and 1st av. in Mesa. An older man owns it named Steve. avoid this place. GAmes i am talking about the worm gear on the mainshaft. I put white lithium grease all over the vss gear that slides into the trans. I drove 20 yards then pulled it...

Ok GAmes thanks. I'm going to pull it off right now and check it out. I replaced the sensor there after he worked on my truck and pull that out and it was ok. What about the gear on the mainshaft. With out seeing a drawing of the assembly could he have put a washer or something in the wrong spot...

yes the speedo gear turns on the vss. The guy that installed the main shaft nut claims the speedo gear on it is meshing and working.

I;ve already searched need better advise. I drove my 1994 ram3500 manual 2wd to AZ from In just after buying it. I lost the mainshaft nut in OK. Didnt have the tools to fix it so i had it fixed at a shop my dad recommended when i got to AZ. Long story short, the guy said he had done it 100...

yea i wish i would have gotten it from the cummins dealer, but i needed one fast didnt know the area and bought that one because i seen a napa. better than autozone in my opinion. I will look up a cummins dealer and buy one and replace it when i get back to indiana. thanks guys

I have a 94 ram 3500 2wd 12 valve manual and its been running not to far past 140 since i;ve gotten to arizona from indiana. I changed the thermostat today and the gauge is moving just a little bit more , but its not doing the usual go to 190 then back down then back to 190. The thermostat is...