Recent Content by Misenheimer

Thanks for the good info. I wish I could have started with it but I will save it for the next time. My belts are working now after I cleared the code, I have no idea what the code was but the P side started working right away. The D side was tight and unable to unlock till I released it from...

I took the module out and put it in another truck and it did not unlock the belts in that truck. I just picked one up from the Dodg dealer for $125. + tax and put it in and NOT Working. Rats!!!! I have a code P1693 that tells me that there is a code in a companion module??? WTf My reader will...

Is that the box that is under the console??? It has a ball in it and I thought that it was part of the trailer brakes. I will give it a wack and see if it gets a better attitude. I had thought that it was the belt winding up on the upper part of the winder making it not big enough to trip the...

I will try that and let you know. It was sitting on flat ground.

My 98. 5 has the seat belts in the seat back, it has been sittinf for several mounts and the belts are stuck in the retracted position. How do I get them back out so I can use them and how do I keep it from happening again?? The drivers side did it several monts ago and I messed with it and it...

So is mine and the hinge at the dash and at the center are both broken. I do not have the missing parts to glue back. Bummer. Has any one made the parts themself?? I think that is the only way to go without just getting rid of it all together and puting a CB or something in its place.

Is there any fix to the arms and the hinge on the drink holder?? I have searched the junk yards with no results. Dodge wants $$$$ and will not sell parts for it ---- too old ---- my *** Thanks Robert

any ideas???

What are you asking for the 47re??

What is the problem with using the scotch lock on the wire at the PCM?? Out of the road grit and corrosion?? Just asking. Thanks

I ordered a Fairbanks shift kit, filter and a plate === $104. I ask what shipping would be and he told me"it won't be much" and it was $18. 75 - I don't knot what not much means to them but 18% on top and not telling me before I ordered it really frost my cakes. BEWARE BEWARE BEWARE BEWARE...

I have the shift kit in with all new solonoids ( 4 ) and it is working with lockup. Now it stacks shift 1-2 as soon as it is moving 2-3 soon after. Will the higher line pressure cause this?? I adjusted the TV cable to where there is no slack in it at full open. Will the 100 ohme resistor delay...

Back under the truck. I was on the connctor for the neutral start switch. my bad

I just ordered a Fairbanks kit with a new steel seperator plate. I have used this one in the past and did like it. I had a failed overrun clutch and defeatng the accumulator fixed it for the last 65k miles. Now another problem has come up --- the connector is flat with three pins and the...

I think that the lockp solonoid is open. It is difficult to get on the pins but the OD solonid will bring down a 9v battery to 190mv the lock up had no change. I think I will put in a shiftkit while I am in there. Who makes the best one?? I have used transgo and it was good. I want a plate to go...