Recent Content by MKresge

Just got my new 2007 3500 and I just don't like how low the front end sits. Does anyone have any opinions on leveling spacers? Polyurethane vs. steel? Any particular brands? I've seen some manufacturer's install instructions and some say they can be installed by letting the front axle hang...

Thanks CBrahs. Around my area in PA its not available at many stations yet.

I've heard conflicting stories about the use of the ultra low sulfur diesel in 2007 engines. Must all 2007 model engines use the ULSD or only those 2007 models whose engines were built after Jan 1, 2007?

Thanks for the info Diesel-Dan. I had absolutely no trouble starting the truck for that whole week. When I noticed the BATT ground disconnected, I listened for the sound of the FASS when starting again but I didn't hear it run. I reconnected the ground and started again (no sound of the FASS). I...

I installed a FASS on my 2002 3500 about 6 weeks ago and a new high pressure pump was installed by Dodge at the same time. Fuel pressure has been about 19-20 psi. About a week ago the ground wire from the FASS was inadvertantly removed so the FASS wasn't working for this past week of driving. I...

I have a 2002 HO 3500 6spd that began losing power (fuel pressure gauge would read ½ to 2 psi on acceleration). I took it back to the Dodge dealership and was told that it needs both a low pressure transfer (lift?) pump and a high pressure injection pump. The truck only has 40K miles so it was...

Thanks for the info. I checked Geno's and I am not sure which boost gauge I need, 0-30 or 0-60 psi? I don't see any FP gauges listed under the Isspro heading but I see that Westach has two, a 15 and a 30 psi. Which would be best? It also says that you need to get creative to hook up these...

I would like to get a 3-pod pillar mount (mine has a speaker in the pillar) and boost, pyro and fuel press gauges. Can someone recommend a good set-up? Part numbers would be a great help. Thanks ____________________ 2002 Quad Cab 3500, long bed, 4wd, 6spd, HO, 4. 10, EZ-Dump, Warn 12K...

Problem solved. Rusty, thanks for the info.

I am a new member and I have a question regarding the gearshift lever on a 6 speed. The lever appears to be rotating as the gear pattern on the knob is turning. I thought it was just the knob but that is tight, so I thought that the shift pattern was an insert in the knob that was moving but...