Recent Content by Mopargunguy440

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff
  1. M

    2nd Gen Non-Engine/Transmission High transfer case temps

    Ive never noticed it above 150 until this trip.
  2. M

    2nd Gen Non-Engine/Transmission High transfer case temps

    Temp gauge coming off the case. I was in 2wd. Thats where the concern came from, couldn’t figure a reason why it’d be so high given the contitions.
  3. M

    2nd Gen Non-Engine/Transmission High transfer case temps

    2002 2500HO NV5600. Was driving on the highway, 500 mile trip, not towing at about 80mph. Transfer case temp was around 210 degrees. Slowed down to 70mph and it hovered around 190 degrees. Fluid level is good. It’s the original transfer case with 237k on it. Any ideas? Outside temp was in the...
  4. M

    03 nv5600 clutch squeak

    I doubt its the bushings in the pedal as it makes the noise when im totally off it. The best way to describe the sound is its exactly like brake squeeking.
  5. M

    03 nv5600 clutch squeak

    The pedal feels fine and no resistance going in and out of gear. Ill check the hyrdolic fluid after i get off work later and update
  6. M

    03 nv5600 clutch squeak

    Im not sure of the details to the clutch replacement. Id imagine its a stock unit though. How would i go about checking the pilot bushing to see if its dry? The trans fluid level is good also the noise is really inconsitent meaning that sometimes it makes it and sometimes not under similar...
  7. M

    03 nv5600 clutch squeak

    So about a week or so ago the clutch (at least thats what i assume it is) started making noise when pulling away from a stop and sometimes when i shift. It sounds like a squeak especially noticable when starting in 3rd. It seems to grab just fine and it was replaced along with the trans when i...
  8. M

    New cummins owner

    For all you manual guys out there what would you recomend for a clutch? And what could i expect power wise from just a programmer? I have a buddy who swears by luk clutches but hes a ford guy. My dads on his 3rd clutch at 204k on his 02 and hes been using southbends.
  9. M

    New cummins owner

    @killer223 i meant to say lift pump not injection pump What service intervals do yall suggest for the filters when i do the lift pump? The fuel filter i was gonna go off my dads word and do it every oil change. As for mods it has a knn filter on it. I was gonna start with a programmer after i...
  10. M

    New cummins owner

    So i finally went green pump last week and picked up an 03 2500 with a nv5600. The truck has about 212k miles on it and from what i can tell is stock and was pretty well taken care of. Because im new to the diesel world i was looking for some input on things i should look out for and or change...
Back
Top