Recent Content by Morsed

The problem is the lamp out system. The TIPM sends a low voltage through the light and needs to read .5 watts resistance, I believe. If the resistance is too low the TIPM will turn the power off, then after a short time it will try again, hence the on off scenario. When I tried to put relays on...

transmission shop called this morning. Second Solenoid pack and mounting plate fixed the problem. Thanks for the looks.. Dave

Vehicle: 2002 jeep Grand Cherokee (Overland) Transmission 5545RE problem: no backup lights (at all) Had transmission shop replace the solenoid pack inside the transmission and now have backup lights if you do not start the vehicle. Once the engine is running the lights will last one shift cycle into...

I used the Fleece controller on mine. I will list the part #s and see if I can get some pictures of the final install once I have the down pipe solved. The hard part was getting the right exhaust elbow and manifold to clear the spring tower. I plan on a trip to the local muffler shop for a down...

It was a stock elbow with the 4" exhaust added. I now have a 04.5-07 elbow and can see the difference between them. I have a section of the 4" tubing with a slip joint on one end. I wonder how hard it would be to put a flare on it so that I could cut the down pipe and weld the bigger flare on...

I am in the final stages of an HE351 vgt install and have a slight snag. Seems like the diamond eye 4" exhaust and the new cast elbow do not have the same diameter so will not mate up properly. Is there any trick to make this connection or do I have to Jerry rig something. Thanks The...

Thank you gentlemen, This is rather tough being so far away and on the end of a cell phone conversation with very bad reception. I have printed the Travel Companion Idaho page and will be doing some calling in the morning. I will also look into the nwbombers.com site for the possibility of...

My daughter is on the way to the Kinyon road fire in Idaho from Enumclaw, Washington and has been having overheating issues since just about Pendleton, Or. She is now just out side of Mountain Home, Idaho and the truck has stopped and she will have to leave it to continue to the fire where she...

doug5cents, Think of this story. . My truck, 03 4x4, would not start while I was up at hunting camp. So we jumped from a running FJ40 Land cruiser and charged the starters battery ( drivers side) Still would not start. Checked for codes only code was for a crank sensor, so I replaced that and...

Tractor jack try the Power Shop in Enumclaw, The Power Shop - MORE POWER TO YOU Dave

Before I paid that much money I would try this fix Dodge truck lumbar repair procedure. Dave

when I was learning to target shoot 22's my father-in-law would say ; squeeze you jerk. .

SSage, Look at on line ordering from Mopar parts at Mopar Parts ~ OEM Dodge, Chrysler, Jeep, Plymouth Parts or Mopar Parts Catalog. look under the cooling system and transmission for lower hose and return lines. The lower looks like about $70 and the return at about $40. They do not list any...

The last time I had to change the water pump, 9 mo. ago. I just removed one of the threaded pipe plugs from the head, filled until fluid came out, installed plug and topped off radiator. I had no problem with an air bubble. Dave

I was wondering about the 90MM hella low beams 90mm Low Beam DE Headlamp Module, H9 bulb for my driving lights. Has anyone tried them yet? Dave