Recent Content by MT McGroin

to answer the question. yes. i got everything sorted. funny though i just had a dead pump last week. after much searching i found that the duetch pac connector had been pulled loose from the wire right at the plug that goes into the FP. the fuel pump was still good and the recently repaired...

PS good call on the placement of the EGT sensor. will be mounting it on the manifold. thanks guys

hi guys, FYI i got my computer back from AUTO COMPUTER SPECIALIST. they did a great job, all fixed up. sent a report of possible causes and even included the wiring diagram for my VIN. the factory manual is hard to follow so this is a major bonus in my eyes. total was less than $300. would...

yup. down pipe

will do. thank you

oh yeah forgot, I have an electronic fuel pressure gauge installed on the pillar. was showing pressure up till this episode. second is a pyrometer but I haven't had the bung welded in yet

John, thank you for taking the time to help me here. I have performed all 3 test situations, all failed. FP will run when on battery directly. I found your earlier thread w the relay info in it and that's what led me to this spot. good point regarding the oil press switch. would it OK to leave...

questions 1. is it ok to run a separate relay off the power supply to the pump to help w the load going through the ECM? 2. since mine is toast can I run a separate power & relay set up w out doing more damage to the ECM? 3. is there a kit that includes all the recommended mods for the wiring...

02' 3500 cab & chassis. 2 wd. 5.9L 5 spd manual. all stock.

stock wiring

guys need suggestions, have the Carter lift pump style set up. pump is mounted to the engine block, not in the tank. power failed recently. checked to see if it was ground (positive lead @ FP harness plug - neg @ battery) issue. still no 12+. checked the relays, all good. pulled out slightly to...