Recent Content by rdraves

After 316K miles it looks like I need to replace at least one of the grid htr relays. I just dropped over a grand in the brakes so I would appreciate any ideas on where to get these. Thanks

brake problems Yes i was have a pulsation in the brakes, almost like a bad ABS but that was replaced last year. I did need new rotors and pads as 130K on those were pretty good. I only question the replacement of the power steering pump but i was told that the "book" suggested that it be...

They replaced the brake booster. It seems to work fine now.

I asked and they said that when they replaced pads/rotor and sand blasted the parts they did not break the hydraulic line. Does this make sense? thanks Bob

2002 dodge with 316K miles. I had a brake job and shortly after when i travel less than 5 MPH and brake the brake peddle is hard and does not depress. it sometimes takes releasing and pumping for the brakes to function again until the low speeds. Local shop replaced the power steering pump and...

With all of the trouble I am having with my 02 i might look at the Ford also.....

Any luck with reman ECU's? I was told $2K for dealer ECU. I am considering a different dealer - I had to ask to have the ECU re-flashed will know tomorrow.

I have my 2002 with 301K miles in the dealership for over two weeks with what feels like a dead throttle. Dealer says the following codes: P1475; P0122; P6093 in the ECM and P0122 in the PCM. Have ordered a TPS from Tim but thought now is possibly ECM is bad. I have asked dealership to check and...

Received a code 0122 TPS low volt on a 2002 with 301K miles. Last TPS replaced about 80K and three yrs ago. Put the new TPS in from Tim's and calibrated between >. 666 volts and 3. 8 volts. I can not clear the code 0122 and the engine is running as if i had not replaced the TPS. the truck runs...

I have a 2002 with about 300k, with a new FASS DPRP pump I am running 10 to 12 psi. Dealer thinks it might be a partially plugged tank filter. Any comments?

i would agree, except there is no drips under the truck after sitting all night

Installed rebuilt VP44 and reman FASS DPRP under warranty in Jan 2012. Been working great until two days ago. It takes 6 to 8 starting cycles to start after sitting overnight. Zero press in morning. After starting in the morning with a lot of white smoke at startup, the truck runs great all day...

Jan 2012 I lost the VP44 and Fass pump. I replaced the same with a rebuilt VP 44 and warranty Fass pump. Today and 5000 mile later i could hardly start the 2002 dodge. It acted as if the truck was in minus 20 and took three tries to start. Ran fine all day. Let the truck sit for about 3 hrs and...

OK guys new shocks it will be. Besides Bilstiens, what is the general opinion of KYB's?

I was told by the Chrysler dealership where I bought the truck that shocks on the diesels performed no benefit. My front end has been kept up and is in good shape. Thanks