Recent Content by RPM_58

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff
  1. RPM_58

    New Recall V06

    I see a lot of discussion regarding the ability to detect a impending separation due to steering misalignment as the adjusting sleeve loosens. This is not the case. The issue is that the Thread Pitch Diameter on the passenger side (outer) drag link might be undersized. This results in the...
  2. RPM_58

    New Recall V06

    I see a lot of discussion regarding the ability to detect a impending separation due to steering misalignment as the adjusting sleeve loosens. This is not the case. The issue is that the Thread Pitch Diameter on the passenger side (outer) drag link might be undersized. This results in the...
  3. RPM_58

    New Recall V06

    Additional Note: If the Adjusting Sleeve threads are within specification (assuming that only the outer drag link arm threads are undersize), then the worst case (out of specification) minimum major diameter ( OD ) of the outer drag link threads (allowed by the “Dealer Service Instructions”)...
  4. RPM_58

    New Recall V06

    My First Post - Wish it was regarding a more positive subject... My 2018 Diesel 2500 (2,600 miles) is on the recall list and I did receive a recall notice. I inspected the drag link jam nut and found it loose, able to be turned by finger. I’ve read the updated (March) “Dealer Service...
See more
Back
Top