Recent Content by RussellSullivan

The Fluid Damper works well on my 06 with manual trans. Is smoother and quieter.

Yikes!

Thank you, The compressor Thanks for all the good info. I am hoping to make time in December to replace the evaporator. It is the only component in the AC system that I haven’t replaced recently. I will inform y’all of the results then. R

Thanks for all the info. My wife and I both like power seats so I'll be looking at the options available in the Big Horn model.

Thanks. And another question. About Bid Horn and Tradesman models. Does the wiring harness under the drivers seat have the connector for power seats even on models that did not come equipped with power seats?

Just wondering about automatic power folding mirrors on new 2500’s. Am thinking about buying one. I live in the middle of nowhere. I don’t park where it’s crowded and I like to see behind me when the engine is off. Do these new models have a way to delete the automatic mirror fold function when...

Well, I replaced the fan clutch (Mopar) and it comes on more often than the old one. Im sure the truck will be "happier" with the change. After evacuating the A/C system and flushing it thoroughly (did the evaporator four times both directions) and installing a new Denso compressor, plus 46 oil...

I had to open a you tube account so I could upload the video. That route didn’t work either. Aaargg!! I’d rather replace a u joint.

Still working with TDR to get the video uploaded. I will order the new fan clutch and the Denso compressor. Thanks to Tuesdak and PMedina for your help.

Thanks for the info and questions. The outside temp is most always over 100 this time of year. Normal, with low humidity. This morning the AC high side pressure was 275 psi at 1500 rpm at 93 degrees ambient temp. It stayed about the same to 2200 rpm which is as high as I went. I can't tell...

There is minor vibration on the pressure line. It is routed properly, held in by plastic clips that separate it from any metal surfaces. When I flush the evaporator I notice more resistance when blowing flush solution in through the pressure side than the suction side. Should there be a...

Well, the folks in town didn’t know. The moaning, now more like a whooooing at higher RPMs is more pronounced especially at around 1500 RPMs. I can feel the vibrations as the engine drops a hundred RPMs and the noise begins when the AC cycles on. Not good. Is it possible that faulty...

I have had good luck with the Banks Exhaust brakes. Have one in an 06 5.9 six speed and one in an 07 5.9 with a 48Re. Had a vac pump problem in one when it was new and Banks immediately replaced it for free. Have about 260k miles on the pair and no other problems. Yes, you have to add the vac...