Recent Content by RWarr

Just did my first service on the rear diff. I used Mobile 1 in the new Mag Hytech cover and all seems good so far.

John, I should have been more specific about the oil capacity so I didn't confuse you the first time. The other posts are correct - the book calls for 3 gallons including one in filter. I don't know why mine has to be odd but that puts mine over the safe level! I checked the dipstick at the...

OneBucsFan Three gallons is one quart too much on mine. 10 in the pan and 1 in filter. The guys at the lube place can't seem to leave the last quart in the gallon jug even when I tell them to. It overfills mine and I'll have to go home and drain about a quart! Codes - Did you happen to...

AutoXray 4000 - 6000 model scanners are generally between $300 to $600 depending on where but found many on ebay. I didn't get one since I decided to go with software and laptop connection so I can see a virtual dashboard like DLeno uses for experimenting with different boxes on the fueling box...

Good Deal Alan!!! I'm glad to hear your truck is feeling better!:) In regards to the OBDII programing, you can do a search in the forums and find some threads on what people are using if you haven't done that yet. I've got an older laptop that I dont use anymore and I think I'm going to...

AGrady I replied to you the other night when they were doing maintenance on the TDR site. Seems like my reply must have gotten zapped into cyberspace when they shut down the forums. I figured I'd try again since "better late than never". The problem I experienced when I plugged in my Edge...

mattymac I'll check when I go to plug the box back in. Also talked to Edge Tech support today. The Tech was not surprised that the boost elbow had caused the overboost code. Sounds like this can happen with the box plugged in also. I thought it was just because I was running without the box...

ttreibel and krabman Thanks for the help and opinions. The gauges are just a matter of me deciding on what and where I want to mount and time to do it! Now I'm motivated and will make it happen. I'm going to take your advice and plug EZ back in on the lowest setting and try that arrangment...

:confused: I know, I know, I shouldn't do anything without the gauges first! Like I said - couldn't stand the temptation any longer. I thought I'd be OK since I had the 4-inch exhaust and I wasn't planning on any more than a test run on the factory set Level 3. I wasn't going to be pulling the...

I have had a new Edge EZ on my workbench for two weeks waiting on a cold air kit and gages. I couldn't stand it anymore and thought I would plug it in for a test drive. Decided to install the boost elbow also. Noticed filter minder was at 35% and the filter looked dirty. Called the shop to see...