Recent Content by scottyconcrete

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff
  1. S

    High engine idle and white/blue smoke and hard starts

    Here is the update... ... We appreciate the link and checked those wires. Found a small knick and repaired. Also found several wires that were damaged due to fire with the previous owner. Repaired those. Wrapped them all and replaced the Coax covers. Durring this time we had the batteries...
  2. S

    High engine idle and white/blue smoke and hard starts

    Here is the update:mad: We received our new FCA from Gino's monday. When we removed the old FCA, there was no rattle when shaken (suggestion in manual). Installed new FCA... ... No change; RPM still @ 832, FRP's still fluctuating, intermittent studder/smoke on startup (reguardless of outside...
  3. S

    High engine idle and white/blue smoke and hard starts

    Good, checked those
  4. S

    High engine idle and white/blue smoke and hard starts

    This is exactly what we were looking for. Threw new troubld codes at startup today. P0116--ECT sensor rationality; P0251--CP3 pump regulator control (FCA); P0628--low voltage detected at lift pump. We ran a few backyard tests. Checked FRP's before start up 1. 7 after the lift pump cycled...
  5. S

    High engine idle and white/blue smoke and hard starts

    Filters on the Air Dog II are only 2 months old????? We were having issues prior to the Air Dog; we thought the lift pump was going out so that is why we installed the Air Dog. We have the fuel filter changed on every other oil change and at our current mileage rate that was about a month ago...
  6. S

    High engine idle and white/blue smoke and hard starts

    So... ... After lots of time and testng, realized the lift pump on the Air Dog II was out (not running). When we first installed the Air Dog II it took about a week for us to realized we pinched the fuel line from the tank to the lift pump. We thought this was our problem as we assume we starved...
  7. S

    High engine idle and white/blue smoke and hard starts

    Could the FCA going bad be caused by a pinched fuel line?? When we had the Air Dog II installed, they ran the line in such a way that the line was pinched between the tank and the frame for a few days until we saw the problem.
  8. S

    High engine idle and white/blue smoke and hard starts

    We have a 2005 3500 cummins 5. 9 turbo truck with 60,000 miles. We have installed an air intake and exhaust, a Smarty Jr. , an Air Dog II. Recently started having hard starts and large amounts of white/blue smoke when starting. This continued whether warm or cold. Returned the programming back...
See more
Back
Top