SnoKing

Snoking I have been following this thread as I own one also. That circuit is complicated due to all the programming of the chip on the board. My brother is an analog designer and has said we could come up with a whole new design and his partner would do all the programming as that is his specialty. I know this doesn't help you but I did research the LLC. And can get you names and mailing addresses if you wanted to write them and see what you could get from them. I have access to the slide pot and display if those are an issue.
My email if you want to discuss further is philcabinets@gmail.com.
Thanks Don

Hi Snoking,
I have some questions I was hoping you might be able to answer regarding your smart controller install. I just recently had Bill K. install a full DTT transmission and I had to find a smart controller since they don't make them anymore. The one I found does not have the microswitch for the 2nd gear kickdown. Does yours have any numbers or anything on it? I know I can build my own bracket if I can just find a darned switch. Any help greatly appreciated.

Thanks,
Jim Pooler