Recent Content by spratt

So far so good without the VA. I am going to check out the Smarty

Continued to act up this am. The code reader showed 1689 which is no communication between the ECM and fuel pump. I removed the Van AAken as it is between the ECM and the VP44 and the problem has not occured over a few miles. I hope the box is the problem [knock on wood] because, if not and...

Thanks It showed p 1693 only. I will connect to a reader today to see if other codes show and will post again. Thanks.

I was driving at 70 mph with cruise on. Suddenly there was no power and check engine light. I pulled over and the truck was still running but would not take throttle. If you barely touched the pedal you could get up to 36 mph. I limped home and on restarting everything was back to normal except...

Hold the gear selector up slightly and if that stops it lube the shift linkage

Hi I put it in about 3 years ago and followed the directions but cannot recall. I did solder the connection and it still is working great

I purchaser a fass ddrp from Geno's a few months ago and just received a letter from them advising the button head screws on the base and mounting bracket may not have been torqued properly at the factory and to check them. Has anybody received this notice and does the pump have to be removed...

When I turn to the right while going slow I can hear what sounds like the brake shield rubbing on the rotor. The noise is associated with the turning of the wheel and it does not occur turning left. I bent the shield a bit and this seemed to help for a while but the noise comes back. Can...

George My email address is pproulx_8@sympatico.ca Thanks again Paul Proulx

Much appreciated fellows. I will remove the sear, repair the seat heat and add some foam. It will give me an excuse to be in the workshop during the holidays.

Thanks Tom. Are you saying remove the seat then the seat covering to get at this area. i have noticed the left edge of the seat shows wear from getting in and out. was the wire you soldered in the grid or leading to it. If I have to take off the seat cover I would like to add a layer of foam as...

I installed the Navone filter about 10,000km ago and the truck has never shifted better.

Thanks for the advice. I am going to poke around under the seat. Figures it would stop working at beginning of winter.

The seat heat on the drivers side stopped working. The high side of the switch flashes for about 1 minute but no heat. The passenger side works fine. Does anybody have any idea of what the problem is and or the fix. Thank you. 2000 slt+, every option except 2 tone and plow prep. Ordered new...

Thanks for the info. I am going to order the ddrp from Geno's.