Here I am

Recent Content by SWithers

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff
  1. S

    Engine/Transmission (1994 - 1998) 12v Valve Spring Pressure Question

    pardon me if this is a repost i tried searching with no luck. i have a 12v that i picked up at the local junkyard. when i set up and measured the valve spring installed height and put the spring in the rimac spring tester. i'm showing 85-90 lbs of seat pressure. piers said that the stock springs...
  2. S

    Engine/Transmission (1994 - 1998) Turbo exhaust housing A.R question

    to the brain trust. holeset turbos are 12cm,14cm,16cm etc. what does this translate to in garrett specs are we looking at . 48, . 63 or are we in the 1. 0 and bigger AR's. i am under the impression that you don't just convert the cm AR to inches. of course we haven't talked about trim...
  3. S

    Engine/Transmission (1994 - 1998) lift pump question

    has anyone made a block off plate for the factory lift pump and installed a EFI electric pump?
  4. S

    Engine/Transmission (1994 - 1998) looking for pump info

    question about lift pump timing. checked mine last night according to piers chart it is set at 16 dgrees. what i am trying ot find out or understand is what are they using to figure out the degree based on lift at TDC. i mean it seems that you set the pump lift to "X"mm of lift at TDC and that...
See more
Back
Top