Recent Content by T_Murph

I'll get you the p/n I used tomorrow. I got it all off ebay.

I went with a pioneer avic 5000nex several years ago and I've been happy with it.

trouble code from the scan tool said the crank sensor was bad.

It was starting fine before I shut it down to address the leaking radiator and leaking crankshaft seal. After replacing those items and a few other things along the way. It wont start now.

Code I'm getting after replacing the crank sensor.

I replaced my clutch switch and the crank position sensor with OEM units. Truck just cranks and cranks but won't fire.

forgot to update! the clutch switch was indeed bad.

The starter solenoid relay in my fuse box isn't sending a "grounded" signal to the starter. Thus my truck is a no crank no start. When I run a wire from the starter solenoid to the battery negative the truck starts fine. I sent my fuse box out assuming it needed repairs to an eBay vendor...

Thanks!

You want the VIN #? Or just normal stuff it's an 04 / 2500 st quad cab 4x4. Nv5600 305hp engine.

I'm in the processing of replacing my hydro booster and master cylinder. The local auto parts store remans failed after 1.5 years not surprising. I'm having a difficult time tracking down the oem part numbers for these items. this is why I've found for they hydro booster #5179891AC is this...

Thank's I'll try that.

I have an 04 2500 with nv5600. I replaced my hydro booster & master cylinder. Yes I did bench bleed the mc before installing. Since then my driver side only caliper engages / locks up daily. If I open the bleeder screw it relives the pressure for about 24 hours. And then the issue comes...

Announcements on my 30th birthday. I can dig it!!