Recent Content by TBerkey

It is an after market dash assembly from LRB Speed. I originally thought the Gauge cluster bolted into the cluster hood after assembly, but they show bolting the cluster to the original metal structure, then putting the new aluminum dash skim on after and the cluster hood is riveted to the dash...

Thank you again. I got the vacuum line together and I think I got the electrical wiring back together. I have to make some modification to the new dash assemble because the directions call for installing the gauge cluster the installing the new dash and I would need to take the entire dash out...

Thank you very much. That is exactly what i needed. I could not find that any where. I was still not able to find the 2nd connection on the def/floor actuator but i will look again tomorrow.

It is a 1995 Dodge Ram 2500 regular cab.

I am reinstalling the heater bow after new AC evaporator and heater core. I did not pay enough attention to the vacuum lines when I disconnected them. I can only find where 3 of the 4 vacuum lines go. Does anyone have a diagram, picture or explain where the 4th line goes. I under stand why no...

Manual. The original 5 speed, I always wished I had the 6 speed or a gear vendors over drive.

I am in Palatka. I did get it running. where are you located?

Sorry for not getting back sooner, this problem backed me up on everything. I did get it running with everyone's help. I got the neighbor to help. I pressurized the fuel tank. I used starter fluid and had the neighbor crank it and give it some throttle. Thank you every one for the help. the P...

I have been a one man show. I will try to get some help, what you say makes sense.

I replaced the fuel filter right away. I filled the filter before putting it on and can prime fuel to the bleeder bolt and to the input banjobolt on P-pump bolt on P-pump. I had bought a pressure gauge just before my mistake but did not put it on until after my mistake. It bounces around when I...

The shut off seems to be moving the full amount when turon;n key to start and run. I have pumped a gallon or more fuel by hand with the lift pump to bleeder bolt and to inlet to P-pump. I even hand pumped until I got a little fuel at cracked open furl injector. when i crank it it is still just a...

It was almost a full tank of gasoline it was about 6 to 1 gas.

I only ran it for 2 min at the most it was barely running by then. it was 2 week or so until i flushed clean diesel through it. I have fuel up to the P-Pump but only get a small amount thru to the injectors, I get some dampness when bleed injector but no pressure. I tried pinching off the return...

I need a replacement P7100 pump for my 1995 12 valve, manual transmission. Doe anyone have any feed back on Pensacola Diesel? Can anyone suggest a mechanic in North Florida in the St Augustine/ Palatka area? After owning the truck for 28 years I can not believe what I did, I put $90 dollars...

Yes, you are right. They where stuck so tight I thought they where machined on the the bolt head but I can pick the off with some effort. Thank you.