Recent Content by TDRdodgeman784

I put a BD stabilizer kit on my truck 6 weeks ago it helps but I did not like how cheep they are my stabilizer kit came with all the bolts that was all a lesser Grade bolts then the Dodge bolts that came on my truck and they tell you to take your Dodge High Grade bolts out and tell you to put in...

That sounds good I am in the torque range can I now ask in that range what torque are you guys setting you lug nuts to on your 3500 DRW trucks

I have torqued my lug nuts to 155 Ft lbs per my Dodge service manual on my 2005 3500 DRW truck flat nuts but I looked at the lug nuts to day and I can see stamp into the end of the lug nuts torque to 140 Ft lbs . I would like to know if some one out there knows the right torque . Is it 140 Ft...

We have a 31 foot Sunnybrook 5th wheel rear kitchen we have used it for 12,000 miles now and have run on a lot of vary rough roads and we have not broke any dishes or cabinets and we do have glass dishes . I just looked my wife has some pans in upper cabinets I would not put them up there but...

Has anyone ever put on there truck a add on transmission cooler. The kit has you cut the return cooling line with a tube cutter and then you put on a compression fitting onto the aluminum cooling tube to connect the hoses to and from the add on cooler. My Question is has anyone had trouble with...

Try rotating your tires I had a slight pull to right on my truck when I bought the truck so I rotated the tires and the pull stopped check tire PSI. if low could pull or check your ball joints Dodges have been known for short ball joint life.

AH64ID THANKS My after turbo Pyrometer probe or gauge has stopped working so I have a new pre turbo Pyrometer gauge on order . I will be drilling the manifold soon. THANKS again AH64ID

AH64ID did you drill and tap the manifold with the turbo on the manifold or did you take the turbo off so metal chips did not go into the turbo.

Just got the high mount I will be intalling it this Saturday. Looks like it is vary easy to install. I think it can be installed in about a half hour.

DO NOT get the reflash till you here from someone that has had it flashed onto there truck and find out if thay lost power and MPG. and if you go to the dealer for any repair work you tell them NOT TO reflash because if your truck is in there shop for repair on any thing thay will reflash with...

Thanks Bob4X4 I will get it done.

I was going to install my new Mag-Hytec DD pan today and found the filter drop down extension kit has no gasket to go between the filter drop down block and the transmission the new filter has a gasket on it. is the filter drop down block just mounted metal to metal . Has anyone put this pan on...

I got a add on transmission cooler with temp switch and fan. The directions tells me to mount the cooler under the pickup bed and take the hot line out of the transmission and put it into the new fan cooler then into the antifreeze cooler then to the front air cooler then back into the...

2 micron filter I live in Minnesota will your your truck start and run and drive below 32 or 0 or -30 with out a heater on the 2 micron filter . I would like to add a 2 micron filter to my truck if it will start and run and drive good in the cold and if water gets past the stock filter will the...

Drive Shaft You can have one made. I have had some made up for some of my trucks in the past. You will have to call some shops where you live to find out who can make them. If the shop you call can not make one up ask them if they know of a shop that can make a shaft up for you and if you hit...