Recent Content by TSjodin

:-laf :-laf :-laf This thread sure left my wife and me laughing for awhile. Wadda crowd!!! Go TDR Oo.

I just called Jordan up at 800 5330306, mentioned that I was a TDR member and he gave me the deal. It was great talking to him, it's nice when you can talk directly to the designer and manufacturer. Thank's Jordan, can't wait to install the controller. Tom

I have a 94 and have a small leak at the coupling which goes to the condenser. I've noticed that the later models have a block which anchors the coupling from moving. I think that it's pretty low on freon now since it is not cooling very well and cycles quite a bit. I have got the tool to take...

Jeff, Look just behind the fuse box under the hood. You will see a couple of places where wires ground to the fender, see if they are loose or corroded. Tighten them anyway. Looking at the schematics this was a point in common I found that could be a problem. By the way you can get...

CPFF, Would you happen to have any drawings and dimensions of the jig so us machinist types could make one up ourselves? Thanks, Tom Sjodin

Please put me on list. I will be gone on vacation till the 11th of June. Hope that dowel pin stays in place, could make for a lousey trip. Thank you Tom Sjodin

I took the blank out, drilled a quarter inch hole just left of center and installed a mini switch leaving the right side of the blank undrilled for a future function. The mini switch is about $5. 00. I still haven't found a use for the lockup since my truck is stock, I don't have an exhaust...

I have a 1994 3500. I have owned it a little over a year and have noticed that when using the brakes hard, like parking a trailer, that the pedal gets hard and I loose vacuum, it's pretty scarry to say the least. If I step on the pedal hard about 10 times the vacuum warning light comes on...