Recent Content by Turbo359

I received both sets of mirrors I ordered from Wyatt Arp Dodge, 2001 manual trailer tow mirrors and 2006 power trailer tow mirrors. I used the instructions that were posted and switched the bases. They went together and work like there supposed to, but I have a 3/4 inch gap on the bottom where...

The truck starts to miss as soon as the tst box starts fueling. It is a random miss, any cylinder when the tst box is fueling.

I put the tst chip and complete wiring harness on another 98 2500 and it works great. I have cleaned and checked the grounds, I installed individual ground wires from the battery to the ecm, pcm and an extra battery cable from the battery to the engine. I had the tst wire harness grounded on the...

I've tried running both chips individually, the tst misses and the edge works fine. I have the pump wire soldered and it seems to have a good connection.

A couple of weeks ago my truck started missing when on the throttle. Got a PO253 code. Checked electrical connections and cleaned grounds because I've had ground problems before. Truck still missed and had a PO253 again. Figured it must be the injection pump. Read alot of posts leaning toward...

My wheels are 16x8 Eagle series 58 polished aluminium.

I have 16x8 eagle aluminum wheels and 315-75-16 pro-comp x-terrains. They stick out a little, not as much as the wheels in the picture.

It was great finally meeting some of the guys from the TDR and was even better when Rob pulled that sled 309' and stopped at the beer tent. He spent 2 hours signing autographs in the pits afterwards. Dodge definately rulled in Armada on Saturday. Turbo359

I was thinking about entering my truck in the local fair truck pull. The way I have my truck setup should I just forget about it or should I give it a shot. I figured I should be able to place better than dead last as long as something doesn't break. How do I take off? Do I put it in drive...

My truck had 52,800 miles when I installed my Edge comp. Ran for about 10 minutes. It was doing real good as I increased the power levels, tried 1,2,3 and then jumped to 5, hit wot, started to launch and then the truck died. Didn't restart until I put the new vp-44 in. Learned about injection...

My truck was missing at hard accelleration. Ended up being the ground wire that I tapped into on the VP-44 harness. Got the ground fixed and its running hard again. It just Rips!!:D