Recent Content by WUrbowicz

Specs on...Brake line rusted out between the front and rear inlet ports of the master cylinder and the HCU block / need to replace or create / 2004.5 Ram 5.9 3500 SRW

Fuel leak somewhere at the CP3 pump / found the high pressure connector line @ the pump that feeds the rail was leaking /tried to tighten the retainer nut and noticed the entire pump housing was moving/ not happy / had replaced this line 2 years ago, this is basically a new line/ WTH/ checked to...

OK isn't Carli warrantied 4 life. y not replace t ball joint?

Hello TDR Ended up removing fuel filter housing to make easier access to Engine mounted ECM, for removal/ except for the need for use of a breaker bar to extract the (3) 10mm bolts,ECM removal went well/ Replaced it with one from 2000 year truck/ No change in lift pump function/ Still no 12V...

thank u BW Next question is do I go @ it from the top and remove the fuel filter housing or do I go @ it from the bottom and remove the starter/ I'm 5'3 and my reach is suspect/ TIA /Warren

hello MB been reading up on ur posts for 2 days now/ thank u for all ur info. and perseverance/ have been having loss of power @ highway speed and loss of tach intermittently for past 6 months with all the improper start up sequence before ignition/ now,no start/ pin #6 @ vp is 12V and...

Hello CLamb Have u installed it yet and what was invovled to change the wiring if so??/TIA/ Warren

Hello A I would love to see a pic or diagram of the wiring harness and sensors involved from the overhead console back to wherever and Is it a plug and play hook-up/ I know the cab lights have a different plug on the non-computer display then the one with it/ TIA/ Warren

Thanks for the replies/ first thing was fuel filter drain, check for water and replaced w/ new filter(ie)bowl refilling quickly w/ fuel/ So, there is a full filter bowl/ Any other suggestions?? TIA/ Warren

cp3 Problems??? Just pulled out the driveway got 1/2 way up the street and the truck died/ no cough, no smoke, engine just quit/ have 04. 5 3500 srw 60k completely stock/engine turns over but no fuel out the exaust smell, ie no fuel to injectors/ drained fuel bowl, refills quickly from LP/...

Thank you Lotero for this post I Just recently installed a 2000 Engine in my 2001 3500 and in order to make room had to bend the APPS in a 180* loop when I slipped it off to the side of the engine bay/ I must have stressed the cables when I did this and I made a mental note to check the...

Thank you for your posts guys, they were very helpfull/ Replaced the ckp sensor behind the starter into the side of the block and plugged in the mysterious plug as shown above/ I got my tach back and no more hard starts/ No more shut downs w/out warning and the engine runs strong/Thats today...

No tach here hopefully are the pic of plug in harness.

hello mh I just did a similar type swap/ Put a 2000 engine into a 2001 3500 w/auto. Left the wiring harness's w/ each original engine/ Have no tach and at times engine will just shut down like a switch has been flipped w/out warning/ Upon restart there will be no lift pump activation or...

Hello Gary Very nice pics/ Can you tell me what the Scale resistance part # would be in your second picture W/# 35713 shown on it/ Just this plastic piece W/ the copper scales please/ My ohms are not registering correctly on my unit/ Anyone else replace their sender due to deteriorating float...