Recent Content by wwjdcars

mclouth ks right before pinion broke, again

Brian Block Built A 14mm Head A Few Years Ago, I Would Like To Find One, Any Help Would Be Appreciated

stock is cool, cant wait to see finished product

I Put 80lb Cummins Springs All The Way Across, We Turn 4500 Rpms And Have Not Hade A Problem, And They Where Only 70 Bucks, Good Luck

What About Your Pinion Bearings, Good, Bad, If Not That, It Wouldn't Be To Deep, I Would Say It Wasn't In Far Enough. Good Luck

anyonr know where to find a steel 19. 5 8 lug wheel to fit 01 3500, thanks for your help

Saturday Night, Emporia Ks 323 Ft In 7500lb Class And 346ft In 8500lb Class, About Time, We Broke 4 Pinions In 5 Pulls. Last Week I Installed An American Axle 14 Bolt 11. 5, Went From 3. 55 To 4. 11, Oh What A Feeling, Life Is Good Again, Thanks For Your Help John Issacs

the harness for the lockup and overdrive shorted out, when they built my transmission they put in a used harness, not a very happy camper, but they are sending me a new one, I took the bed off the truck last night , going to go ahead and install the fass this weekend, when the harness gets here J...

my dyno on meth this was with the old transmission, will dyno again with new transmission

FIRST PRONG IS OVERDRIVE, SECOND IS POWER, AND THIRD IS LOCKUP

Tried To Attach Photo Of Plug, But I Am Rather Slow, So I Will Put It In My Photos

We Are Going To Dyno This Weekend, I Want To See What The transmission Gives Me, I Could Feel A Big Difference, We Were At 267, I Bet We Make It To 320 To The Ground With Just The transmission Change. Next Week We Start The Big Jump, We Are Adding A Ported Oringed Head, Three Piece Manifold, Ats Intake, Ddr...